Furuno NAVpilot-1000 handleiding
Handleiding
Je bekijkt pagina 4 van 89
ii
SAFETY INSTRUCTIONS
Follow the safety instructions listed below and throughout this manual to prevent damage to your
equipment or vessel and to prevent harm to the operator or other personnel on-board. The results
of failing to follow the instructions and guidelines outlined herein are listed below.
WARNING
Indicates a condition that can cause death or serious injury if
not avoided.
CAUTION
Indicates a condition that can cause minor or moderate injury
if not avoided.
Warning, Caution
Mandatory Action
Prohibitive Action
Do not open the equipment unless
you are well familiar with electrical
circuits.
Only qualified personnel should work
inside the equipment.
Do not set the course changing
speed too high.
The boat will be turned too sharply at
the course change, which could create
a very dangerous situation.
Do not use the autopilot in the
following situations:
- Speed 40 knots or higher
- Navigating in a narrow channel
- Entering or exiting a harbor
- Area of heavy marine traffic
- Cruising where the field of view is
poor due to narrow visibility, fog, mist,
or rain
- Vessel is stopped
Do not use the SIMULATION mode
on the boat.
The rudder may move suddenly. This is
a special-purpose mode for technicians.
Observe the following cautions when
using the autopilot:
- Maintain a vigilant watch
- Watch for drifting of vessel
WARNINGWARNING
WARNINGWARNING
Use the correct fuse.
Use of a wrong fuse can cause fire or
damage the equipment.
In an emergency, manually steer the
vessel.
The autopilot cannot avoid vessels, etc.
automatically.
Before starting or resuming auto
steering, confirm that the actual
heading matches the heading shown
on this autopilot.
If the displayed heading is not the same
as the actual heading, the vessel may be
steered in an unexpected direction,
which could result in an accident such as
collision.
The processor unit must be
connected to the power supply
through a breaker (local supply). The
breaker must be installed at a location
that is easy to operate in an
emergency.
If the rudder is unintentionally moved or
auto steering cannot be canceled, do as
follows to stop the autopilot.
• For analog steering system: Use the
steering control changeover feature of
the steering system to stop the auto
steering, then turn the breaker off.
• For solenoid steering system: Turn the
breaker off.
Bekijk gratis de handleiding van Furuno NAVpilot-1000, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Furuno |
| Model | NAVpilot-1000 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 9190 MB |
