Furuno CH-500 handleiding
Handleiding
Je bekijkt pagina 24 van 113
1. OPERATIONAL OVERVIEW
1-12
1.8.5 Interference from other equipment
While observing the sonar picture, you may encounter occasional or intermittent noise
and interference. These are mostly caused by on-board electronic equipment, engine
or propeller noise, or electrical noise from other sonars being operated nearby.
Typical interference is displayed on-screen in a manner similar to the figure below.
You can suppress this kind of interference by using the interference rejector.
To use the interference rejector, do the following:
1. Press the MENU key to open the menu.
2. Press to select the menu bar.
3. Press or to select [COM1].
4. Press to select [Interference], then press to show the [Interference] settings.
5. Press to select [On]. The interference rejector is now active. The IR indicator
( ) is shown in the following location, depending on the display mode in use.
• All Horizontal modes: Top-right of the screen.
• Vertical and Echo Sounder modes: Top-left of the screen
6. Press the MENU key to close the menu and apply the changes.
To disable the interference rejector, repeat the above procedure and, at step 5, press
to select [Off].
1.8.6 Interference from marine life
Marine life, such as plankton, can cause interference. The interference rejector can
suppress this type of interference.
To use the interference rejector, see section 1.8.5.
Bekijk gratis de handleiding van Furuno CH-500, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Furuno |
| Model | CH-500 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 15432 MB |
