Furman PL-PRO DM C E handleiding
Handleiding
Je bekijkt pagina 6 van 36
6
PL-PRO DMC E OWNER’S MANUAL
EXTREME VOLTAGE SHUTDOWN (EVS) INDICATOR:
The Extreme Voltage LED indicator is normally o. It is located within the meter lens assembly directly above the blue voltage /
current LED’s, though during normal use it will NOT be visible.
The Extreme Voltage indicator monitors a hazard common in the entertainment, remote broadcast, and AV contractor industries:
wiring faults. For example: accidental connecon to 330VAC where 220-240VAC is expected, or an open series neutral from a 208 to
330VAC electrical service. The Furman EVS circuit senses voltages that are so high that operaon would be impossible and shuts the
power down before damage can occur.
Upon inially applying power to these units, the Extreme Voltage indicator will light and a red “Extreme Voltage” label will appear at
the top of the meter lens if the input voltage is above the extreme voltage cuto.
NOTE: If the mains power is above the high cuto voltage and has caused the EVS circuit to remove power from the PL-PRO DMC
E’s outlets, it cannot restore power without the operator manually turning the unit o, then on again. Avoid turning the unit back on
without rst checking the source of the problem and changing the AC source (if necessary).
PROTECTION OK INDICATOR:
Although the Furman SMP circuit assures virtually maintenance-free protecon from transient voltage spikes and surges, nature has a
way of occasionally creang electrical forces that are beyond the capabilies of ANY surge suppression device to absorb without some
degree of damage (such as a direct lightning hit in an outdoor applicaon). In the rare instance that this occurs, the green “Protecon
OK” LED indicator located at the boom right of the meter lens assembly will dim.
NOTE: Furman’s Classic Series power condioners do not compensate for high or low AC line voltage. If you frequently move your
rack to dierent locaons, derive power from generators, use very long extension cords, travel internaonally, or are in an area prone
to brownouts, you may benet from the use of one of Furman’s AC Voltage Regulators.
SWITCHABLE DIGITAL VOLTAGE AND TRUE RMS CURRENT METER:
Furman’s laboratory precision AC digital voltmeter connually measures incoming voltages within a typical tolerance of +/-1.5VAC [+/-
3.0VAC]. It should be noted that the voltage reading is incoming.
Furman’s laboratory precision True RMS digital current meter connually measures the total circuit AC load, within a typical tolerance
of +/- 0.5 amp. Because these meters feature true RMS technology, the current readings are accurate regardless of load condions
(capacive, inducve, or resisve).
To switch between voltage and current, press the buon labeled “Line Voltage/Current”. Hold this buon down for two seconds to dim
the brightness of the display.
VOLTAGE RANGE INDICATOR:
This indicator is located in the lower le corner of the digital volt / amp meter lens assembly. When AC voltage is within 5 volts (+/-)
of a nominal 216 to 244 VAC, this tri-color indicator will be green (opmal). However, if the voltage is between 205 to 215VAC or
between 245 to 255 VAC, the indicator will turn amber (cauon - not opmal). If the incoming voltage is in an extreme range (below
205 or above 255), the indicator will turn red. This range is far from opmal, and may be potenally damaging to some equipment.
USB CHARGER:
The Furman PL-PRO DMC E’s USB charger provides an easy way to recharge many popular electronic accessories as well as cellular
communicaon devices by simply plugging the re-charge cord into the front panel socket. Please note that as there are currently
many standards for USB, some devices may not be compable with our charger.
INLET AC CORD SECURITY CLAMP:
The Furman PL-PRO DMC E’s detachable AC cord is supplied with a two piece security clamp. The two piece chrome wire securityclamp
(located In the AC cord bag) is easily aached to the threaded holes on either side of the AC inlet, and can be installed in seconds with
a standard Phillips screw driver.
Bekijk gratis de handleiding van Furman PL-PRO DM C E, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Furman |
| Model | PL-PRO DM C E |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5032 MB |
