Full Boar FBANS-019 handleiding
Handleiding
Je bekijkt pagina 9 van 16
9
AIR NEEDLE SCALER SAFETY WARNINGS
• Do not connect tool to pressure that potentially exceeds 150 psi (10.3 bar).
• Only use clean, dry and regulated compressed air at 6.2 bar (90psi)
• Only technically skilled operators should use the air tool.
• Do not overreach. Only use in a safe working place. Keep proper footing and
balance at all times.
• Keep bystanders away (when working in an area where there is a likelihood of
through traffic of people). Clearly mark off your operating area.
• Only wear gloves that provide adequate feel and safe control of triggers and
any adjusting devices.
• The tool must be disconnected from the air supply and rested on a flat
surface when not in use.
• Always wear impact-resistant eye protection with side shields during
operation of the tool.
• Appropriate hearing protection shall be worn.
• The risks to others shall be assessed by the operator.
• Ensure the tool is correctly lubricated during use. Only use the correct
lubricant as specified in this manual.
• Slips, trips and falls are major causes of workplace injury. Be aware of slippery
surfaces caused by use of the tool and also of trip hazards caused by the
airline hose.
• Proceed with additional care in unfamiliar surroundings. Hidden hazards may
exist, such as electricity or other utility lines.
• This tool is not intended for use in potentially explosive atmospheres and is
not insulated from coming into contact with electric power.
• Never use oxygen or combustible gases for operating pneumatic tools as this
could create a fire and explosion hazard.
• Do not discard the manual and safety instructions.
• Do not use the needle scaler for anything other than needle scaling. Do
not attempt to fit any other accessory on the tool other than needle scalers.
Ignoring these warnings can lead to serious injuries.
• For overhead work, wear a safety helmet.
• Ensure the workpiece is securely fixed.
• The use of the tool can expose the operator's hands to hazards including
impacts, cuts, abrasions and heat. Wear suitable gloves to protect hands.
• Hold the tool correctly; be ready to counteract normal or sudden movements
and have both hands available.
• Release the trigger in the case of an interruption to the air supply
• Check the material of the work piece and ensure adequate respiratory
protection such as a mask is worn otherwise serious illness can occur.
• Check the working environment and the material to ensure the dust created
Bekijk gratis de handleiding van Full Boar FBANS-019, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Full Boar |
| Model | FBANS-019 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2184 MB |
