Fujitsu B24W-7 LED handleiding

43 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 12 van 43
Important notes
If you operate the device with the sw ivel arm or a similar accessory, it
must not b e turned through 180°.
The device may only be operated in wide format (0° landscape mode) and high format (90°
portrait mode). The buttons are located at the bottom in the middle of the monitor in wide format
(0° landscape mode) and at the left-hand side of the monitor in high format (90° portrait mode).
Store this manual close to the device. If you pass the device on to third
parties, you should pass this man ual on with it.
We recommend that you place your device on a durable, non-slip surface. In view
of the many different nishes and varnishes used on furniture, it is possible that the
feet of the device may mark the surface they stand on.
Avoid using high volumes for a long period of time, to prevent causing damage to your hearing.
Warning against excessive volume from headphones: excessive volume from headphones
can cause hearing loss. Setting the equaliser to the maximum value increases the
headphones output voltage and thus increases the sound pressure.
Power cable
Use the supplied power cable only.
Use the following guidelines if it is necessary to replace the original cable se t.
The female/male re ceptacles of the cord set must meet IEC60320/CEE-22 requirements.
The cable has to be HAR -certi ed or VDE-certied. The mark HAR or
VDE will appear on th e outer sh eath.
For devices which are mounted on a desk or table, type SVT or SJT cable se ts may be
used. For de vices which sit on the oor, only SJT type cable sets m ay be used.
The cable set must be selected according to the rated current for your device.
If necessary, replace the original power cable with a regular ground ed 3-core mains lead.
Transporting the device
Device,Transpo rtationRetransportation
Transport all pa rts separately in their o riginal packaging or in a packaging which
protects them f rom knocks and jolts, to the new site.
Do not unpack them until all transportation manoeuvres are completed.
If the device is brought from a cold e nvironment into the room where it will be used ,
condensation may occur. Before ope rating the device, wait until it is absolutely dry
and has reached approximately the same temperature as the installation site.
8 Fujitsu

Bekijk gratis de handleiding van Fujitsu B24W-7 LED, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkFujitsu
ModelB24W-7 LED
CategorieMonitor
TaalNederlands
Grootte2795 MB

Caratteristiche Prodotto

Kleur van het productGrijs
Jaarlijks energieverbruik28 kWu
Gewicht verpakking8400 g
Energie-efficiëntieklasse (oud)A+
Aan/uitschakelaarJa