Frigidaire GMOS1266SS handleiding
Handleiding
Je bekijkt pagina 9 van 72
D.
ALIGNING THE WALL PLATE
Area E
Hole A
HoleB
Draw a horizontal line on wall at the
bottom of “Rear Wall Template”.
Horizontal Line
Horizontal Line
C
L
3/8" TO EDGE
NOTE: IT IS VERY IMPORTANT TO
READ AND FOLLOW THE DI
RECTIONS
IN THE INSTALLATION INSTRUCTIONS
BEFORE PROCEEDI
NG WITH
THIS
REAR WALL TEMPLATE.
This Rear Wall Template serves t
o position the bottom
mounting plate and to locate the horizontal exhaust
outlet.
1. Use a level to check th
at the template is positioned
accurately.
2. Locate and ma
rk at least one stud on the left or
right side of the centerlin
e.
It is important to use at least one wood
screw mounted firmly in a stud to s
upport the weight
of the microwave. Mark two add
itional, evenly spaced
locations for the supp
lied toggle bolts.
3. Drill holes in the marked locatio
ns. Where there is
a stud, drill a 3/16" hole for
wood screws. For hole
s
that do not line up with a st
ud, drill 5/8" holes for
toggle bolts.
DO NOT INSTALL THE M
OUNTING PLATE
AT THIS TIME.
4. Remove the template from the rear wall.
5. Review the Installation Instru
ction book for your
installation situation.
Locate and mark
holes to align with h
oles in the
mounting plat
e.
IMPORTANT:
LOCATE
AT LEAST ONE
STUD ON EITHER SIDE OF
THE CENTERLINE.
MARK THE LOCATION FOR 2
ADDITIONAL, EVENLY
SPACED
TOGGLE BOLTS IN
THE MOUNTING PLATE
AREA.
Locate and mark
holes to align with hol
es in the
mounting plat
e.
IMPORTANT:
LOCATE
AT LEAST ONE
STUD ON EITHER SIDE OF
THE CENTERLINE.
MARK THE LOCATION FOR 2
ADDITIONAL, EVENLY
SPACED
TOGGLE BOLTS IN
THE MOUNTING PLATE
AREA.
Trim the rear
wall template al
ong the dotted
line.
12"
4"
Darle vuelta a la hoja para consultar la
versión en Español.
Draw a Vertical Lineon
Wall from Centerof Top
Cabinet
Centerline
notches
1
Draw a vertical line on the wall at the
center of the 30" wide space.
2
Draw a horizontal line on the wall at
the bottom of “Rear Wall Template”.
3
Find a wall stud in area "E" of
mounting plate Refer to section 1B.
Finding the wall studs.
4
For attaching the mounting plate
into stud drill a 3/16" hole into wood
stud. Drill a 5/8" hole for toggle bolt
in 1 other location (Hole A or Hole B)
NOTE: DO NOT MOUNT THE PLATE
AT THIS TIME.
NOTE: Holes A and B are inside area E. If
neither of Holes A and B are not in a stud, find
a stud somewhere in area E and draw a circle
to line up with the stud. It is important to have
at least one wood screw mounted firmly in a
stud to support the weight of the microwave.
Set the mounting plate aside.
Installation Instructions
EN-8
Bekijk gratis de handleiding van Frigidaire GMOS1266SS, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Frigidaire |
| Model | GMOS1266SS |
| Categorie | Magnetron |
| Taal | Nederlands |
| Grootte | 11447 MB |
