Frigidaire FRMS274TAV handleiding
Handleiding
Je bekijkt pagina 35 van 152
16.3 More about your advanced
water filter
The PurePour Connect™ PWF-1™
FPPWFUO1, PurePour Connect™ PWF-2™
FPPWFUO2 ice and water filter system is
tested and certified by IAPMO R&T against
Standards 42, 53, 401 and NSF/ANSI/CAN
372CSA B483.1 in PurePour Connect™
PWF-1/PWF-2 for the reduction of claims
specified on the Performance Data Sheet.
Visit Frigidaire.com for more information.
Do not use with water that is
microbiologically unsafe or of unknown
quality without adequate disinfection
before or after the system. Use systems
certified for cyst reduction on disinfected
waters that may contain filterable cysts.
Test & certification results
• Rated Capacity - 125 gal / 453 L for
PurePour Connect™ and ice and water
filter
• Rated service flow - .50 gal/min
• Operating Temperature: Minimum:
33°F, Maximum: 100°F
• Maximum rated pressure - 100 lbs/in²
• Recommended minimum operating
pressure: 30 lbs/in²
PurePour Connect™ Authentication
Only for models: GRMC2273, GRMG2272
The refrigerator contains a water filter
authentication system to protect you from
the harm that can occur when using
counterfeit filters. We recommend you use
only the PurePour Connect™ water filter
with this appliance. Using any other filter
can cause an error (Er FA) to appear on
the appliance control display.
Errors can occur:
• If you remove and reinsert an authentic
expired filter into the appliance.
• If you install an authentic, but incorrect
filter.
• If you install a non-authentic filter.
• If you do not install the filter properly.
In the cases above, the appliance control
display may show an error code related to
the filter authentication, and Replace
Water Filter appears on the display. You
can still use dispensing functions while the
error displays.
Press and hold the Water Filter button for
3 seconds to dismiss the error. You can
dismiss the error twice. On the third
appearance, the error code permanently
displays on the appliance control until you
install a new authentic filter.
16.4 Replacing your PurePour
Connect™ water filter
The water filter is located at the top right
side of the refrigerator compartment.
In general, you should change the water
filter every 6 months to ensure the highest
possible water quality. Water Filter Status
on the user interface prompts you to
replace the filter after a standard amount
of water (125 gal / 453 L for PurePour
Connect™) has flowed through the
system.
If you have not used your appliance for a
period of time (during moving for
example), change the filter before
reinstalling the appliance.
It is not necessary to turn the water supply
off to change the filter. Small amounts of
water may be released during the filter
replacement.
1. Turn off the ice maker.
2. Pull the water filter cover forward.
Cover drops down to allow access to
the filter.
3. Remove the filter by pushing on the
end/face of the filter.
4. Slide the old water filter cartridge
straight out of the housing and discard
it.
5. Unpack the new filter cartridge. Using
the alignment guide, slide it gently into
ENGLISH 35
Bekijk gratis de handleiding van Frigidaire FRMS274TAV, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Frigidaire |
| Model | FRMS274TAV |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 17385 MB |
