Frigidaire FCVW3025SS handleiding
Handleiding
Je bekijkt pagina 6 van 48
6
Parts included in your hood
1 - Vent
1 - Grease Filter with
Charcoal Filter
4 - 0.45 x 1.3 cm
mounting screws
Parts Needed
2 - UL listed wire connectors
Duct work as required
Wall or roof cap with damper to match vent
system as required
Vent clamps/duct tape as required
UL listed or CSA approved ½” strain relief
Tools/Materials required
Drill
1¼” (3.0 cm) drill bit
⅛” (0.3 cm) drill bit for pilot holes
Pencil
Wire stripper or utility knife
Tape measure or ruler
Caulking gun and weatherproof caulking
compound
Flat-blade screwdriver
Phillips screwdriver
Saber or keyhole saw
For cabinets with recessed bottoms:
Two - 2” (5.1 cm) wide filler strips. Length and
thickness determined by recess dimensions.
Four flat head wood screws or machine screws
with washers and nuts (to attach filler strips).
IMPORTANT
Observe all governing codes and ordinances.
• It is the installer’s responsibility to comply
with rating plate. The model/serial rating
plate is located inside the range hood on the
left side (See page 2 for location). Range
hood location should be away from strong
draft areas, such as windows, doors and
strong heating vents.
IMPORTANT
• Cabinet opening dimensions that are shown
must be used. Given dimensions provide
minimum clearance. Consult the cooktop/
range manufacturer installation instructions
before making any cutouts.
• Grounded electrical outlet is required. See
“Electrical Requirements” section.
• All openings in ceiling and wall where canopy
hood will be installed must be sealed.
• Remove protection from the product before
installation (if applicable).
For Mobile Home Installations
The installation of this range hood must conform
to the Manufactured Home Construction Safety
Standards, Title 24 CFR, Part 328 (formerly the
Federal Standard for Mobile Home Construction
and Safety, Title 24, HUD, Part 280) or when
such standard is not applicable, the standard
for Manufactured Home Installation 1982
(Manufactured Home Sites, Communities and
Setups) ANSI A225.1/NFPA 501A, or latest edition,
or with local codes.
A. 66” (167 cm) suggested min. - top of range hood to floor.
B. 30” (76.2 cm) min. cabinet opening width.
C. 13” (33.0 cm) cabinet depth
D. 36” (91.4 cm) base cabinet height
A
B
C
D
LIST OF MATERIALS
LOCATION REQUIREMENTS
Bekijk gratis de handleiding van Frigidaire FCVW3025SS, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Frigidaire |
| Model | FCVW3025SS |
| Categorie | Afzuigkap |
| Taal | Nederlands |
| Grootte | 6084 MB |
