Frigidaire FCVW3025AW handleiding
Handleiding
Je bekijkt pagina 12 van 48
12
INSTALL RANGE HOOD
WARNING
Fire Hazard
Electrically ground the blower. Use copper
wire.
Connect ground wire to green ground
screw in terminal box. Failure to do so can
result in death, fire or electrical shock.
Complete Installation
1. Replace grease filter if removed. See the
“Range Hood Care” section.
2. Check the operation of the range hood fan and
light. See “Range Hood Use” section. If range hood
does not operate, check to see whether a circuit
breaker has tripped or a household fuse has blown.
Disconnect power and check wiring connections.
NOTE
To get the most ecient use from your range
hood, read “Range Hood Use” section.
RECIRCULATING VERSION
NOTE
Remove protective film entirely.
1. Lift the range hood up under cabinet and
determine final location by centering beneath
cabinet. Mark on the underside of cabinet the
location of the 4 keyhole mounting slots on the
range hood (See slots dimensions on page 10).
Set range hood aside on a covered surface.
A
A. Keyhole slot
A
2. Use ¹⁄₈” (3 mm) drill bit and drill 4 pilot holes as
shown.
NOTE: Make the drill holes on the thin area of the slot.
A
A. Drill pilot hol
e
3. Install the 4 - .45 cm x 1.3 cm mounting screws
in pilot holes. Leave about ¼” (6.4 mm) space
between screw heads and cabinet to slide
range hood into place.
(6.4 mm)
Power Supply Cable Installation
1. For direct wire installations, run the home
power supply cable according to the National
Electric Code or CSA standards and local
codes and ordinances.
There must be enough wiring from the fused
disconnect (or circuit breaker) box to make the
connection in the hood electrical terminal box.
NOTE
Do not reconnect power until the
installation is complete.
2. Remove the screw from the terminal box cover.
Remove terminal box cover and set aside.
3. Remove the power supply knockout from the
top or rear of the vent hood (depending on the
incoming location of your home power supply
cable) and install a UL listed or CSA approved
½” strain relief.
4. Using 2 or more people, lift the hood into final
position. Tighten the strain relief screws.
5. Position the range hood so that the large end
of the keyhole slots are over the mounting
screws. Then push the hood toward the wall
so that the screws are in the neck of the slots.
Tighten the mounting screws, making sure the
screws are in the narrow neck of slots.
Recirculation Vent Cover
For installations which are recirculating the air
exhaust, the recirculation vent cover must be
removed.
Remove the recirculating vent cover by removing
the 2 mounting screws with a Phillips screwdriver.
NOTE: For installations which are venting out the
roof or wall, the recirculating vent cover must
remain in place.
Do not remove as unit will not perform properly.
To complete the installation, go to “Make
Electrical Connection” section on page 11.
NOTE: Consider use the A measure for 7”(17.8 cm)
round transition and B measure for recirculating
system.
Bekijk gratis de handleiding van Frigidaire FCVW3025AW, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Frigidaire |
| Model | FCVW3025AW |
| Categorie | Afzuigkap |
| Taal | Nederlands |
| Grootte | 6084 MB |
