Frigidaire FCRC3022BW handleiding
Handleiding
Je bekijkt pagina 16 van 20
Occurrence Possible cause Solution
Entire appliance does not operate. Appliance not connected. Make sure power cord is plugged properly into outlet. Check your fuse box or breaker box
to make sure the circuit is active.
Electrical power outage. Check the house light to be sure. Call your local electric company for service outage infor‐
mation.
Oven Problems
Occurrence Possible cause Solution
Poor baking results. Many factors affect baking results. Use proper oven rack position. Center food in the oven and space pans to allow air to cir‐
culate. Preheat the oven to the set temperature before placing food in the oven. Adjust the
temperature and baking time recommended in the recipe.
Flames inside oven or smoking from
oven vent.
Excessive spills in oven.
Grease of food spilled onto the oven bot‐
tom or oven cavity.
Wipe up excessive spills before turning on the oven.
If flames or excessive smoke are present when using broil, refer to Setting Oven Controls.
Oven smokes excessively when boil‐
ing.
Incorrect setting. Refer to Setting Oven Controls.
Meat to close to the broil element or burn‐
er.
Reposition the broil pan to provide proper clearance between the meat and broil element
or burner. Remove excess fat from meat. Cut remaining fatty edges to prevent curling, do
not cut into lean.
Grease build up on oven surfaces. Regular cleaning is necessary when you broil frequently. Grease or food splatters cause
excessive smoking.
Oven control panel beeps and dis‐
plays any F or E code error.
Oven control detected a fault or error con‐
dition.
To clear the error press the OFF key on the control panel. Once you clear the error code,
try the bake or broil function. If the F or E code error repeats, turn off the power to the ap‐
pliance and wait 5 minutes, and then repower the appliance. Set the clock with the correct
time of day, and try the bake or broil function again. If the fault recurs, press the OFF key
to clear.
Oven portion of appliance does not
operate.
The regulator gas is OFF. Make sure the regulator gas is turned ON. Refer to Installation Instructions.
The time of day is not set. The clock must be set in order to operate the oven. Refer to Setting Oven Controls.
Desired function is not set. Make sure the oven controls are set properly for the desired function. Refer to Setting
Oven Controls and this checklist.
Cooktop Problems
Occurrence Possible cause Solution
Surface element is too hot or not hot
enough.
Incorrect surface control setting. Adjust power level setting.
Surface element does not heat or
does not heat evenly.
Incorrect surface control knob is used for
the element needed.
Make sure that you use correct surface control knob for the element needed.
Cookware is light weight or warped. Use only flat, evenly balanced, medium or heavyweight cookware. Lightweight pans heat
unevenly and food may burn easily.
Drip bowls are pitting or rusting. Foods with acids, such as tomatoes, will
cause corrosion if allowed to stand in/on
bowls.
When cool, remove and wash drip bowls as soon as possible after a spill.
This is normal. Houses located along sea coasts are exposed to salt air. Protect bowls as
much as possible from direct exposure to salt air.
Drip bowls have changing or distort‐
ing colors.
Bottom of hot cookware extends beyond
surface element and touches cooktop sur‐
face, causing the drip bowl to discolor.
Pan size should match the size of the surface element.
Replacement drip bowls may be purchased from your appliance dealer.
Self-Clean Problems
Occurrence Possible cause Solution
Self-clean does not work. Oven control not set properly. Refer to Setting Oven Controls.
Oven racks discolored or do not slide
properly.
Oven racks left in oven during self-clean. Remove oven racks from the oven cavity before starting self-clean cycle. Clean by using a
mild abrasive cleaner following manufacturer's instructions. Rinse with clean water, dry,
and replace in oven.
Soil not completely removed after
self-clean.
Self-clean cycle interrupted. Refer to Setting Oven Controls.
Excessive spills on oven bottom. Remove excessive spills before starting self-clean.
Areas such as oven frame, the door liner
outside the oven door gasket, and the
small area at the front center of the oven
bottom are not in the self-clean area, but
get hot enough to burn on residue.
Clean these areas before starting self-clean cycle. Clean burned-on residue with a stiff ny‐
lon brush and water or a nylon scrubber. Be careful not to damage the oven gasket.
16 ENGLISH
Bekijk gratis de handleiding van Frigidaire FCRC3022BW, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Frigidaire |
| Model | FCRC3022BW |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 2178 MB |
