Handleiding
Je bekijkt pagina 34 van 40
34
• Restart the unit according to the start instructions. Never use a knife or other sharp
instrument to scrape ice inside.
Cleaning inside the appliance
After defrosting you should clean the appliance internally with a weak solution of bicarbonate of
soda. Then rinse with warm water using a damp sponge or cloth and wipe dry. Wash the baskets
in warm soapy water and ensure they are completely dry before putting them in the appliance.
Water will flow into the defrost drain, it doesn't matter if the amount of water is not large, this
water arrives in the recovery tank located at the back and evaporates naturally.
Caution: Make sure that no pieces of food are clogging the defrost drain.
If you're going on vacation
If your appliance is not to be used for several months, remove all food, turn off and unplug the
appliance from the outlet. Clean and dry the inside and outside of the appliance thoroughly. Also
leave the door open, blocking it if necessary, to prevent condensation, odors, mold.
Moving the unit
After any movement, it must not be connected for 4 hours. This delay allows the coolant to
be adjusted.
Energy saving tips
• The appliance should be located in the coolest area of the room, away from heat
producing appliances or heating ducts, and out of the direct sunlight.
• Let hot foods cool to room temperature before placing in the appliance. Overloading
the appliance forces the compressor to run longer. Foods that freeze too slowly may
lose quality, or spoil.
• Be sure to wrap foods properly, and wipe containers dry before placing them in the
appliance. This cuts down on frost build-up inside the appliance.
• Appliance storage bin should not be lined with aluminum foil, wax paper, or paper
toweling. Liners interfere with cold air circulation, making the appliance less efficient.
• Organize and label food to reduce door openings and extended searches. Remove
as many items as needed at one time and close the door as soon as possible.
Changing the light bulb
This device consists of light-emitting diodes (LEDs). This type of
diode cannot be changed by the consumer. The lifespan of these
LEDs is normally sufficient for no changes to be made. If,
however, and despite all the care taken during the manufacture
of your device, the LEDs are defective, please contact your
service department for any intervention.
Door reversal instructions
Attention ! :
Avant de changer le sens d’ouverture de la porte, veuillez débrancher l’appareil.
Votre appareil intègre une porte réversible. Vous pouvez choisir de l’ouvrir par la gauche ou par la
droite. Pour changer le sens d’ouverture de la porte, veuillez suivre les instructions suivantes :
1. Turn off the unit and remove all items from the door trays.
2. Remove the top hinge and the holes caps of the appliance door.
Bekijk gratis de handleiding van FrigeluX CVNF177BI, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | FrigeluX |
| Model | CVNF177BI |
| Categorie | Vriezer |
| Taal | Nederlands |
| Grootte | 7276 MB |
