Handleiding
Je bekijkt pagina 73 van 90

77 77
 Warning: Prior to beginning work on systems containing FLAMMABLE REFRIGERANTS, safety checks are necessary to ensure that the risk of ignition 
is minimized.
NOTICE: Individuals working on these units must be EPA 608 Certified along with A2L Refrigerant Training.
 Warning: Refrigerant 32 cannot be used as a retrofit for R-410A refrigerant. The mixing of refrigerant across classes is prohibited. R-32 Is not a drop 
in replacement for R-410A.
General Work Area: All maintenance staff and others working in the installation area shall be instructed on the nature of work being carried out. Work in confined 
spaces as defined by the Occupational Safety And Health Administration shall be avoided.
 Warning: Job site should be examined for safety hazards such as flammable vapors, ignition sources, ventilation and confined spaces. Create a safe 
perimeter with barriers and signs designating a flammable area. 
 Warning: Work shall be undertaken under a controlled procedure so as to minimise the risk of a flammable gas or vapor being present while the work 
is being performed.
Check for presence of refrigerant: 
•  The area shall be checked with an appropriate refrigerant detector prior to and during work, to ensure the technician is aware of potentially toxic or 
flammable atmospheres.
•  Ensure that the leak detection equipment  being used is suitable for use with all applicable refrigerants, i.e. non-sparking, adequately sealed or intrinsically 
safe.
•  Under no circumstances shall potential sources of ignition be used in the searching for or detection of refrigerant leaks. A halide torch (or any other detector 
using a naked flame) shall not be used.
•  The following leak detection methods are deemed acceptable for all refrigerant systems:
1. Electronic leak detectors  may be used to detect refrigerant leaks but, in the case of FLAMMABLE REFRIGERANTS, the sensitivity may not be adequate, 
or may need re-calibration. (Detection equipment shall be calibrated in a refrigerant-free area.) Ensure that the detector is not a potential source of 
ignition and is suitable for the refrigerant used. 2. Leak detection fluids are also suitable for use with most refrigerants but the use of detergents 
containing chlorine shall be avoided as the chlorine may react with the refrigerant and corrode the copper pipe-work.
If a leak is suspected, all flame sources shall be removed/extinguished.
If a leakage of refrigerant is found which requires brazing, all of the refrigerant shall be recovered from the system per EPA guidelines. 
Presence of fire extinguisher: If any hot work is to be conducted on the refrigerating equipment or any associated parts, a class ABC Rated fire extinguishing 
equipment shall be available to hand. Have a class ABC Rated  fire extinguisher adjacent to the charging area.
WARNING: Electrical Shock Hazard
Disconnect all power to the unit before starting maintenance. All electrical connections and wiring MUST be installed by a qualified 
electrician and conform to  all  codes which have jurisdiction. Failure to do so can result in property damage, severe electrical 
shock or death.
WARNING: This Product uses R-32 Refrigerant
Do not use means to accelerate the defrosting process or to clean, other than those 
recommended by the manufacturer.
When not installed, the appliance shall be stored in a room without continuously 
operating ignition sources (for example: open flames, an operating gas appliance or 
an operating electric heater.
Do not pierce or burn.
Be aware that refrigerants may not contain an odor.
WARNING:
Refrigeration System under High pressure
Do not puncture, heat, expose to flame or incinerate. Only certified refrigeration technicians should service this 
equipment. R-32 systems operate at higher pressures than R22 equipment.  Appropriate safe service and 
handling practices must be used.
Refrigerant
Safety Group
A2L
R-32 SEALED SYSTEM REPAIR
General Information
Bekijk gratis de handleiding van Friedrich WallMaster WCVT12B30A, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Friedrich | 
| Model | WallMaster WCVT12B30A | 
| Categorie | Airco | 
| Taal | Nederlands | 
| Grootte | 17785 MB | 







