Friedrich WallMaster WCVT12B30A handleiding

Airco

Friedrich

90 pagina's

PDF beschikbaar

Handleiding

15 15

WARNING

Electrical Shock Hazard

Make sure your electrical receptacle

has the same conguration as your air

conditioner’s plug. If different, consult

a Licensed Electrician.

Do not use plug adapters.

Do not use an extension cord.

Do not remove ground prong. Always

plug into a grounded 3 prong outlet.

Failure to follow these instructions

can result in death, re, or electrical

shock.

Make sure the wiring is adequate for your unit.

If you have fuses, they should be of the time delay type. Before you install or relocate this unit, be sure that the

amperage rating of the circuit breaker or time delay fuse does not exceed the amp rating listed in Table 206.

DO NOT use an extension cord.

The cord provided will carry the proper amount of electrical power to the unit; an extension cord may not.

Make sure that the receptacle is compatible with the air conditioner cord plug provided.

Proper grounding must be maintained at all times. Two prong receptacles must be replaced with a grounded receptacle by a certied electrician.

The grounded receptacle should meet all national and local codes and ordinances. You must use the three prong plug

furnished with the air conditioner. Under no circumstances should you remove the ground prong from the plug.

Test the power cord.

All Friedrich room air conditioners are shipped from the factory with a Leakage Current Detection Interrupter (LCDI) equipped power

cord. The LCDI device on the end of the cord meets the UL and NEC requirements for cord connected air conditioners.

To test your power supply cord:

1. Plug power supply cord into a grounded 3 prong outlet.

2. Press RESET (see Figure 207).

3. Press TEST, listen for click; the RESET button trips and pops out.

4. Press and release RESET (Listen for click; RESET button latches and remains in). Check that the green LED light is on. The power cord is ready. for use.

Once plugged in, the unit will operate normally without the need to reset the LCDI device. If the LCDI device fails to trip when tested or if the power supply

cord is damaged, it must be replaced with a new power supply cord from the manufacturer.

NOTICE

Do not use the LCDI device as an ON/OFF

switch.

Failure to adhere to this precaution may

cause premature equipment malfunction.

WARNING:

TEST BEFORE EACH USE!

1. PRESS RESET BUTTON.

2. PLUG LCDI INTO POWER

RECEPTACLE.

3. PRESS TEST BUTTON,

RESET BUTTON SHOULD

POP UP.

4. PRESS RESET BUTTON

FOR USE.

DO NOT USE IF ABOVE

TEST FAILS.

RESET

TEST

Green LED

Indicator

Light

(Illuminated

when ready

for use)

SPECIFICATIONS

Electrical Data -Power Cord

Figure 208 (LCDI Power Cord)

Bekijk gratis de handleiding van Friedrich WallMaster WCVT12B30A, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.