Freggia WISA105 handleiding
Handleiding
Je bekijkt pagina 20 van 64
INSTALLING THE WASHING MACHINE
WATER CONNECTION
The mains water pressure must be between 0.05 and 1.00 Mpa
(0.5 - 10 bar.)
• Before connecting the washing machine, open the valve and allow a certain
quantity of water to ow out in order to clean the pipes of any sand or rust. This
operation is particularly important in the case where the washing machine has
been left standing for a long time or when connecting to a new water supply
system.
• The ll hose must be connected to the mains supply using a ¾” threaded
connection.
N.B. On electronic washing machines tted with a dual solenoid valve (hot and
cold water), connect the red hose to the hot water supply valve and the other
hose to the cold water supply valve.
If a hot water supply is not available, both hoses must be connected to the cold
supply using the tting supplied (see g. 8)
• Connect the ll hose ( g. 9).
N.B. Washing machines and condensation type washer/driers must be
connected to the mains water supply using the new hoses provided with the
appliance. The old hoses must not be re-used.
• During the wash, the water supply valve must be fully open.
• The drain hose must be positioned at a height of between 60 cm and 90 cm
( g. 10).
• If the water is drained directly into the drainage system, the free end of the drain
hose must be inserted in a pipe of internal diameter not les than 40 mm.
• The drain hose connection to the drainage system must not be hermetically
sealed, as this would cause a build up of air in the siphon and allow water to leak
out.
If the wash water is drained into a washbasin, sink or other similar system, the free
end of the hose must be reinforced at the bend using the bracket supplied with
the washing machine. Place the hose over the edge of the washbasin and anchor
the bracket in such as manner that prevents the hose from falling ( g. 11). The
washbasin outlet must be clean and must allow the water to ow freely.
In the under-worktop versions, screw in the feet until the spring is fully compressed, thus allowing the appliance to be
installed under the worktop (Fig. 6B).
20
INSTALLING THE WASHING MACHINE
Bekijk gratis de handleiding van Freggia WISA105, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Freggia |
| Model | WISA105 |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 8441 MB |
