Handleiding
Je bekijkt pagina 10 van 40
10
INSTRUCTIONS FOR THE INSTALLER
Act as follows:
• Remove the racks and burners.
• By means of a straight spanner L, unscrew the nozzle U (g.8) and substitute it with the corresponding one.
• Tighten the nozzle strongly.
• DOUBLE CROWN BURNER: (Fig. 8/A)
• Unscrew the screws (V) and remove the cover (C);
• Unscrew the injector with a English wrench (L)
• Fit the corresponding gas injectors (U) instead, in accordance with the marking of the injectors and the gas
characteristics table.
• Block the injectors vigorously.
• Fit the cover (C) and tighten the screws
• ADJUSTING THE BURNERS
The lowest ame point must always be properly adjusted and the ame must remain on even if there is an abrupt shift
from the maximum to the minimum position.
If this is not so, it is necessary to adjust the lowest ame point as follows:
• start the burner up
• turn the tap up to the minimum position (small ame)
• remove the knob from the tap rod
• introduce a at-tip screwdriver in the hole F of the tap (g. 9) and turn the by-pass screw up to a proper
adjustment of the lowest ame point.
As regards G30 gas burners, the by-pass screw must be tightened completely.
MAINTENANCE
• REPLACING THE POWER SUPPLY CABLE
If the power supply cable should be replaced, it is necessary to use a cable with a section of 3x0.75mm
2
, type
H05V2V2-F or H05RR-F, complying with the regulations in force for the hob with gas burners. For the hob with electric
plates and power under 1500W 3x1mm
2
power cable should be used.
The connection to the terminal board must be eected as shown in g. 10:
brown cable L (phase)
blue cable N (neutral)
green-yellow cable (ground)
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualied persons in
order to avoid a hazard.
The manufacturing rm refuses all responsibility for any possible imprecision in this booklet, due to misprints or clerical
errors. It reserves the right to make all the changes that it will consider necessary in its own products, without eecting
the essential characteristics of functionality and safety.
INSTRUCTIONS FOR THE INSTALLER
Bekijk gratis de handleiding van Freggia HP640VGT, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Freggia |
| Model | HP640VGT |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 4095 MB |
