Handleiding
Je bekijkt pagina 30 van 200
16. TROUBLESHOOTING
Error code Description Possible causes of the error Solution
“Acoustic signal upon
ignition. No error code
displayed”
The hood com-
mand does not
work
LIN cable damaged or badly con-
nected to the hood electronic board
Please check the connection. If the error
persists, please contact After Sales Service
ER03
Hob switches off
after 10 sec.
Continuous key activation detected.
Water or pan placed on the control
panel.
Remove water or pan from the ceramic
glass surface and control panel.
ER21
Hob switches
off.
The internal temperature of elec-
tronic parts is too high.
Let the hob cool down.
Please check if the hob has sufficient ventil-
ation.
If the error persists, please contact the
After-Sales Service.
E2
Corresponding
cooking area
switches off.
Empty or unsuitable pan.
Pan or ceramic glass surface tem-
perature too high.
Electronic component temperature
too high.
Let the hob cool down.
Use a suitable pan.
Do not heat empty pans.
E3
Corresponding
cooking area
switches off.
Unsuitable pan.
The pan is losing its magnetic prop-
erties and may damage the induc-
tion hob.
Use a suitable pan.
The error is automatically cancelled after 8
seconds and the cooking area can be used
again.
If any other errors occur, the pan must be
changed.
If the error persists, please contact the
After-Sales Service.
E6
Hob does not
switch on.
Power supply voltage and/or fre-
quency is out of range.
Check mains voltage and/or frequency.
If necessary, contact the After-Sales Ser-
vice.
E8
Cooking areas
are turned off.
Fan fault.
Fan blocked by dust or fibres.
Clean and remove foreign bodies from the
fan.
If the error persists, please contact the
After-Sales Service.
E4-E5-E7-E9-ER20-
ER22-ER31-ER36-ER42-
ER47-EA-EH
Disconnect the hob from the power supply.
Wait a few seconds, then reconnect the hob to the power supply.
If the problem persists, call the After Sales Service and specify the error code that appears on the
display.
17. MAINTENANCE -
REPAIR AND
CONFORMITY
• Make sure that maintenance on elec-
trical components is only carried out
by the manufacturer or by the service
technicians.
• Make sure that damaged cables are
only replaced by the manufacturer or
by the service technicians.
When contacting the service depart-
ment, please provide the following in-
formation:
• Type of fault
• Device model (Art./Cod.)
• Serial number (S.N.)
This information can be found on the
identification plate. The identification
plate is affixed to the bottom of the
device.
Information on the product pursuant
to EU regulation no. 66/2014
Reference standards:
EN/IEC 60350-2
EN/IEC 50564
This appliance has been designed,
manufactured and sold in compliance
with the EEC directives.
30
Bekijk gratis de handleiding van Franke FSM 7081R HI, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Franke |
| Model | FSM 7081R HI |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 24248 MB |
