Franke 392-14 handleiding
Handleiding
Je bekijkt pagina 14 van 40
ADJUSTING THE AIR FLOW
CHANGING THE AIR VOLUME VIA
REPROGRAMMING CONTROL
The speeds are reprogrammable from 1 to
10 V.
Upon delivery, the settings are 3 V for
speed 1, 5 V for speed 2 and 10 V for speed
3.
A B C D E
Always start by adjusting the lowest speed
setting and then go on to the higher
speeds. There must be a lower voltage at
speed 1 than at speed 2 and a lower volta-
ge at speed 2 than at speed 3. Start with
whole volts and make fine adjustments to
tenths of a volt.
Activate programming mode
All settings must be made in programming
mode.
+
5 s.
Press and hold buttons A and B for approx.
5 seconds. The indicator lights are illumi-
nated during this period. When they start
flashing the control is in programming
mode.
Attention!
If no button is pressed for 30 seconds,
programming mode is exited and the
previously set voltages remain.
Save settings
Once programming is complete, save the
settings by holding in buttons A and B for
approx. 5 seconds. During this period the
indicator lights are illuminated. When they
go out, the settings have been saved.
Reprogramming speeds
Activate programming mode
Select the speed you want to change by
pressing button C, D or E.
1V 0.1V
The selected button is illuminated and the
voltage is indicated via flashes. First button
A which indicates whole volts, then button
B which indicates tenths of a volt.
Raise the voltage by pressing button A.
Each press of the button gives 1 volt more
and is indicated by an extra flash.
The same procedure applies to button B
(tenths of a volt).
5 s.
Lower the voltage by holding a speed but-
ton in for 5 seconds. The voltage then falls
and is adjusted to the lowest possible set-
ting. From there you can step up to the des-
ired voltage. Save the settings.
Factory reset
Activate programming mode
+
5 s.
To revert to the factory settings, hold in
buttons A and E for 5 seconds. During this
period the indicator lights flash. When they
go out, the reset has been completed.
14
991.0506.009/D000000006909/180373/2021-10-05
Bekijk gratis de handleiding van Franke 392-14, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Franke |
| Model | 392-14 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4217 MB |
