Handleiding
Je bekijkt pagina 3 van 40
EN
- 3 -
REAR PANEL
CHIME
CH 1
CH 1
CH 2CH 1 REM. WALL PANEL CH 3 CH 4 CH 5
VOX 1 VOX 2
EMERGENCY IN
CHIME
CH 2-5
VOX 3
REMOTE MUTE
EMERGENCY IN | REM. MUTE
ZONE MICROPHONE
REMOTE WALL PANEL
1
2
3
CH 1 | PAGING MIC
CH 2 | 3 | 4 | 5
AUX | PLAYER
4
5
6
AUX 1 AUX 2 AUX 3 REC OUT PRE AMP VOICE PRIORITY (VOX) FM ANTENNA
R
L
R
L
R
L
R
L
PRE OUT
AMP IN
ATTENUATOR PRIORITY
ZONE OUTPUT SPEAKER OUTPUT
ALL ZONES: 480 W RMS (MAX)
EACH ZONE: 240 W RMS (MAX)
TONE CONTROL
480 W RMS
COM
4 Ω
70 V
100 V
~115 V AC, 50/60 Hz, FUSE: T12 A 250 V
~230 V AC, 50/60 Hz, FUSE: T6.3 A 250 V
POWER CONSUMPTION: 680 W
BLUETOOTH® ANT.
AC SELECT
ZONE MICROPHONE
RS-485 + AUDIO
COM
100 V
LINE
CH 2-5 CH 2-5 CH 2-5
CHIME
VOX 2
PHANTOM
48 V
LINE
MIC
CHIME
CHIME CHIME CHIME
VOX 3
PHANTOM
48 V
LINE
MIC
CHIME
VOX 3
PHANTOM
48 V
LINE
MIC
CHIME
CH 2-5
CHIME
VOX 3
PHANTOM
48 V
LINE
MIC
CHIME
PHANTOM
48 V
LINE
MIC
CHIME
BASS TREBLE
3 WIRE 24 V
VOX 3
PA MIXING AMPLIFIER
MAX-480Z
100 V
ZONE 4 ZONE 3 ZONE 2 ZONE 1
COM
100 V
COM
100 V
COM
100 V
COM
100 V
ZONE 5
COM
100 V
PA AMPLIFIER MAX-480Z
CH 1 | PAGING MIC
Z 1
CH 2
Z 2
CH 3
Z 3
CH 4 AUX | PLAYER
Z 4
CH 5
Z 5
AUX 1
AUX 2
AUX 3
MODE
VOL
PROTECT
PRIORITY
CLIP
SIGNAL
FM USBPLAYER
1 2
16
3 654
7
8
9
10
1113 12121415
21
19 182122 20
43 5 6 7 8 9 11
10 1312
17
16 15 14
18
19
a bc d
a b
1.- VOX 1/VOX 2/VOX 3: controls for sensitivity adjustment to give priority to the EMERGENCY IN,
CH 1, and CH 2-5 inputs respectively over the other signals. Depending on this setting, the signal level
required at the inputs to cut audio from other sources will be higher or lower. Please note the order of
priority of the amplifier inputs, for more information see OPERATION - INPUT PRIORITY.
2.- REM. WALL PANEL: connection port for remote wall panel, RJ45 connector. For more information see
section OPERATION - REMOTE WALL PANEL INPUT.
3.- CH 1|PAGING MIC, CH 2, CH 3, CH 4, CH 5: VOX audio inputs, balanced combo connectors (XLR
and 6.3 mm jack) and euroblock (20). In addition, these inputs have a DIP switch (19) to adjust the
sensitivity of the MIC/LINE input, activate phantom power and enable/disable VOX priority (VOX 2 for
CH 1|PAGING MIC and VOX 3 for CH 2, CH 3, CH 4 and CH 5) and CHIME priority (CHIME CH 1 for
CH 1|PAGING MIC and CHIME CH 2-5 for CH 2, CH 3, CH 4 and CH 5).
4.- AUX 1/AUX 2/AUX 3: stereo auxiliary inputs for connection of audio devices such as mixers, computers,
etc. 2 x RCA connectors.
5.- REC OUT: stereo recording output with line level, 2 x RCA connectors.
6.- PRE OUT/AMP IN: pre-amplifier stage signal output (PRE OUT) and amplifier stage input (AMP IN),
RCA connectors. These inputs and outputs have a jumper to connect these 2 stages for the equipment
to function as a whole. If you want to use only the pre-amp stage, remove the jumper and connect your
amplifier to the PRE OUT output; or if you want to use the amp stage, remove the jumper and connect
your mixer/pre-amp output to the AMP IN input.
7.- ATTENUATOR PRIORITY - 3 WIRE: 100 V audio output for message priority on 3-wire attenuators.
For more information, see section OPERATION - 3rd WIRE PRIORITY.
8.- ATTENUATOR PRIORITY - 24 V: 24 V output for message priority on attenuators with priority relay
(4-wire attenuators). This output is at 0 V if no priority is activated, and will provide 24 V when priority is
activated. For more information, see section OPERATION - 24 V PRIORITY.
9.- FM ANTENNA: FM antenna connection input.
10.- TONE CONTROL - BASS: 100 Hz cut-off frequency low pass filter that attenuates/enhances
low frequencies.
11.- TONE CONTROL - TREBLE: high pass filter with 10 kHz cut-off frequency which attenuates/enhances
high frequencies.
12.- BLUETOOTH ANT: Bluetooth signal antenna.
13.- AC SELECT: power supply voltage selector. If you need to change the voltage you should be aware
that the fuse must be modified as specified on the product.
14.- 115/230 V amplifier power supply input .
15.- ZONE MICROPHONE: port for zone microphone connection, RJ45 connector. For further information
see section OPERATION - ZONE MICROPHONE INPUT.
Bekijk gratis de handleiding van FoneStar MAX-480Z, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | FoneStar |
| Model | MAX-480Z |
| Categorie | Speaker |
| Taal | Nederlands |
| Grootte | 6915 MB |
