Follett 25CI425W-L handleiding
Handleiding
Je bekijkt pagina 20 van 52
20 25CI425A/W, 25HI425A, 50CI425A/W, 50HI425A
Ice machine operational and diagnostic sequences
The wiring diagrams that follow illustrate the circuitry of Follett ice machines used with 12 series ice dispensers.
Both normal operation (stages 1—8) and non-normal diagnostic sequences showing torque-out for use in
troubleshooting are shown.
Circuitry notes
§ Bin signal is contact closure only — DO NOT SUPPLY POWER.
Normal operation – Stage 1
Power is supplied to L1 of the control board, the POWER LED light begins ashing. The ice level bin thermostat in
the dispenser is closed and calling for ice, supplying contact closure to the control board. The LOW BIN LED will be
on. The control board will now go through the start-up sequence. The board checks the water sensors (located in
the reservoir) for continuity between the common probe (B) and the high probe (C). If continuity is not sensed, the
water ll valve (P21) is energized.
5
2
1
Start
Run
Compressor
T.O.L.
MAINTENANCE
LOW WATER
TIME DELAY
SLEEP CYCLE
MAKING ICE
LOW BIN
POWER
SERVICE
HI AMPS
HI PRESSURE
DRAIN CLOG
CLEANER FULL
High
Pressure
Switch
R
S
C
Gearmotor
Start
Relay
Start
Relay
N
L1
Fan
A B C D
Water Sensors
RESET
Fill
Valve
Drain
Valve
3
4
2
Bin T-Stat
Clean Switch
Drain Clog Sensor
P6
P21
P20
P19
P3
P22
P4
AUGER
WATER LEVELS
BIN
P11
HI PRS
L1
R
S
C
RED
WHITE
WHITE
BLACK
BROWN
BLUE
RED
BLACK YELLOW
Compressor
Electrical Box
COMPRESSOR
1 2 3 4 5 6 7 8
BLACK
N
P15
Ice Dispense Input
Bekijk gratis de handleiding van Follett 25CI425W-L, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Follett |
| Model | 25CI425W-L |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7101 MB |