Festo EPCS-BS-60-400-5P-A-ST-M-H1-PLK-AA handleiding

Niet gecategoriseerd

Festo

28 pagina's

PDF beschikbaar

Handleiding

Festo — EPCS-BS — 2023-11e

Installation

• Take product weight into account

14 Technical data.

7 Mounting

WARNING

Risk of injury due to unexpected movement of components.

The drive can move freely in the voltage-free state. This can cause unexpected movements of the

connected mechanics and crush parts of the body.

• Bring moving parts of the mechanical system into a safe position.

• Mounting product è Operating instructions for electric cylinder EPCC-BS.

8 Installation

WARNING

Risk of injury due to electric shock.

• For the electrical power supply with extra-low voltages, use only PELV circuits that guarantee a

reinforced isolation from the mains network.

• Observe IEC60204-1/EN60204-1.

Damage to the device due to non-approved potentials at the pins

• Power connection:

• Do not connect pin3

• Logic connection:

•

Apply the logic supply [Logic Pin 1] and the IO-Link communication signal C/Q [Pin 3] at least

50 ms after the load supply 24 V DC [Power Pin 1]. For example, ensure the switch-on delay by

interposing relay contacts.

• Disconnect the logic supply [Logic Pin 1] and the IO-Link communication signal C/Q [Pin 3] after a

shutdown, after an interruption or before restoring the load supply 24 V DC [Power Pin 1].

• EMCS-ST is not hot-plug capable: 24V level to the digital outputs DO1/DO2 [Pin 2/3] or the

IO-Link communication signal C/Q [Pin 3] only after connecting the reference potentials GND/L–

[Pin 4/8].

• Disconnect the digital outputs DO1/DO2 [Pin 2/3] and the IO-Link communication signal C/Q

[Pin 3] at least 50 ms before the power supply connections GND/L– [Pin 4/8] and 24VDC/L+

Disconnect [Pin 1]. For example, ensure the switch-off delay by interposing relay contacts.

• GND and L– connections:

• Apply the Power, GND [Pin 2] and Logic, GND/L– [Pin 4/8] connections to one potential.

Forexample, ensure the same potential by using a common fixed power supply or an electrical

connection of the two 0 V DC GND potentials.

Connect the power cable to the [Power] connection of the integrated drive EMCS-ST and to a PELV

fixed power supply.

2. Connect the logic cable to the [Logic] connection of the integrated drive EMCS-ST and to a

controller or to a IO-Link master.

Bekijk gratis de handleiding van Festo EPCS-BS-60-400-5P-A-ST-M-H1-PLK-AA, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.