Handleiding
Je bekijkt pagina 15 van 30
Page 15 of 30
10.4.2 Powering on control
To turn refrigeration control power on, press and hold for approx. three seconds. The display will read
“On” while the button is depressed. When the control powers on, the display will read the current set point (a
number “1” thru “9” ). The compressor run indicator will illuminate on the display, meaning that the
compressor is running. (Note: the control may already be in the on mode when shipped from factory).
To turn refrigeration control power to off, press and hold for approx. three seconds. The display will read
“Off” while the button is depressed. When the control powers off the display will flash back and forth between
the relative current case temperature and “Off”. The compressor run indicator will be off on the display.
When refrigeration control is in the off-mode cabinet lights and evaporator fans will still operate, but the
compressor will not turn on causing the case to gradually reach room temperature.
10.4.3 Adjusting the set point
The set point is what determines how cold the display case will hold food and beverage. To adjust the set point press and
hold the button approx. three seconds until the display begins to flash a number. Then press the use the button
to scroll number up (colder) or press the button to scroll number lower (warmer). There are nine (9) available set
points numbers, the higher the number of the set point, the colder the display case will run, with setting “9” being the
coldest and setting “1” being the warmest. Once you have chosen your desired setting press the button again to
confirm your choice.
10.4.4 Entering Manual Defrost Mode
In order to initiate a manual, defrost press and hold the button approx. three seconds. The control will read “dEF”
while the button is being held. The defrost is initiated when the defrost mode indicator illuminates on the display. The
control display will then return to reading the case temperature. When the defrost mode indicator turns off the defrost
is complete and the compressor will turn back on illuminating the compressor run indicator .
10.4.5 Error codes
It is possible for error codes to be displayed on the control screen. In the event of a malfunction an alarm will sound and
the alarm indicator will be displayed on the display. An error code or codes will flash intermittently on the display. If
there are multiple codes, the display will continuously cycle through them. The following photo shows error code “E0” as
an example.
Bekijk gratis de handleiding van Federal UCRSL7233C, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Federal |
| Model | UCRSL7233C |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 3848 MB |
