Handleiding
Je bekijkt pagina 18 van 30
Page 18 of 30
10.8 PLACING PRODUCT IN CASE
• Determine desired shelving location before placing product in case. Product must be removed to readjust shelf
location and angle.
• Do not overhang the front or rear of shelves with product. Improper clearance in front and rear of shelf will block
the refrigerated air flow and will cause product loss.
• Do not block the slots along the front and rear air discharge slots. Covering these slots will block the refrigerated
air flow and will cause product loss.
• The display deck is removable for cleaning and can become dislodged in shipment. To ensure proper airflow and
performance of the case, make sure that the display deck is pushed completely down into the plastic evaporator
tub.
• Allow refrigerated models to run for at least two hours before placing pre-chilled product into unit.
NOTICE:
Case must be stocked with pre-chilled product only. Product should be at or below 40°F (4.5°C)
before adding it to the display case. Use a refrigerator to pull down product that is above 40°F
(4.5°C). This display case is a temperature holding product only. It will not pull down product that
is above the recommended temperature.
Bekijk gratis de handleiding van Federal UCRSL3633C, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Federal |
| Model | UCRSL3633C |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 3848 MB |
