Handleiding
Je bekijkt pagina 10 van 30
Page 10 of 30
(7) SHELVING INSTALLATION & REMOVAL (OPTION)
7.1 SHELF BRACKETS AND SUPPORTS INSTALLATION
1. Turn the light switch to the off position.
2. Follow the instructions in the illustration below and insert (1) of the shelf brackets in the desired shelf standard slot
on one side of the case. Place the additional bracket in the same shelf standard slot on the opposite end of case. The
bracket with a clear plastic cord retainer clip must be on the side with the shelf light.
0v NOTCH
6v NOTCH
4
1
2
3
4
INSTALLATION
REMOVAL
2
3
1
TOP HOOK
BOTTOM TAB
SHELF BRACKET
SHELF STANDARD
1. Place shelf bracket top hook into desired shelf
standard slot.
2. Lift shelf bracket top hook to allow shelf bracket
bottom tab to clear shelf standard slot.
3. Swing shelf bracketbottom tab into shelf standard
slot.
4. Place the desired shelf bracket notch of 0, 6, or 12
degrees onto bottom of shelf standard slot.
1. Lift shelf bracket up to allow shelf bracket notch
to clear the bottom of shelf standard slot.
2. Swing shelf bracket bottom tab out of shelf
standard slot.
3. Drop shelf bracket down to allow shelf bracket top
hook to clear top of shelf standard slot.
4. remove shelf bracket top from shelf standard slot.
CLEAR BUMPER
TOWARDS END PANEL
3. Hang one end of the shelf light housing on the front notch of a shelf bracket and then the other end of the shelf light
housing on the notch of the shelf bracket on the opposite end. Note: On models without shelf lights, use a shelf
support instead of a shelf light housing.
4. Push shelf light cords into plastic shelf cord retainer clip located on the inside of the shelf bracket.
6. Remove the cap from the appropriate female light sockets. Important: Grip each side of cap firmly and wiggle and
pull cap straight out of socket. Do not roll cap during removal. Incorrect removal of cap may cause damage to
electrical connection
7. Plug in shelf light by aligning the male pins on the appropriate shelf light cord plugs with the female light sockets and
push together. IMPORTANT: Do not roll plug during insertion.
8. Hang one end of the shelf support on to the rear notch of one shelf bracket and then on the rear notch of the shelf
bracket on the opposite side.
9. Place supplied shelving onto shelf supports as outlined in the appropriate “Shelf Installation” section of this manual.
Bekijk gratis de handleiding van Federal UCR3633S, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Federal |
| Model | UCR3633S |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 3848 MB |
