Handleiding
Je bekijkt pagina 30 van 37
- 30 -
CONTROL PARAMETERS
Table 1 - Control Parameters
Parameter Description
Control Setpoint
1
2
3
4
5
6
7
8
9
Compressor Cut in [°F]
39.0
Compressor Cut out [°F]
36.0
34.7
33.5
32.2
31.0
29.7
28.5
27.2
26.0
Compressor Min On Time
10 min
Compressor Min Off Time
3 min
Compressor Max Run Time
90 min
Defrost Termination Temp [°F]
43.0
Time to first defrost
8 hr
Time to subsequent defrost
8 hr
Defrost duration
30 min
Defrost on demand differential [°F]
20.0
Delay for defrost on demand
5 min
Time delay to the next defrost on demand
30 min
ERROR CODES
Error codes may be encountered if either the controller or the display case is malfunctioning. The
following is a list of error codes that may be encountered.
Table 2 - Error Codes and Resolutions
Code
Description
Cause
Resolution
E0
Temperature probe
error
Probe signal is interrupted or
short-circuited
Check to ensure probe wires and quick disconnect
are secure in control.
Check probe resistance to table below. If 0
resistance is present check wiring insulation. If
infinite resistance is present check for breaks in
wiring (meter will likely read overload or very high
in the mega-ohm range).
Ensure that probes are wired per the wiring
diagram provided.
Replace probe if other remedies fail, or if probe
resistance deviates from “Table 3” below
E1
Defrost probe error
See E0
EE
Unit parameter
reading error
Operating conditions
Remedy abnormal operating conditions. The
control is rated to operate in a range of 14 to
122°F (-10 to 50°C) and less than 90%RH non-
condensing.
Replace control if problem persists.
EF
Operating
parameter reading
error
See EE
Bekijk gratis de handleiding van Federal SSRC-2452, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Federal |
| Model | SSRC-2452 |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 6182 MB |
