Handleiding
Je bekijkt pagina 26 van 63
-
26
-
Joining Cases (No End Glass Between)
DETAIL B
SLIDE EDGE OF
TOP JOINING TRIM
UNDER PLASTIC
GLASS LIP
DETAIL C
ONCE TOP JOIN TRIM
IS IN DESIRED LOCATION
ATTACH TO CASE WITH (2)
8-18 SELF DRILLING SCREWS.
ALIGN CASES
AND JOIN TOGETHER
WITH (4) 1/4-20 SCREWS
AND NUTS.
ALIGN CASES
AND JOIN TOGETHER
WITH (4) 1/4-20 SCREWS
AND NUTS.
B
C
1. If cases are a Counter Top Models, cut holes in counter top as shown in Cabinet Preparation section
In this manual.
If cases are a Floor Models, the cases are joined in the same manner but bases will also need to be
joined as described in next section.
2. Push cases together and align front and rear of cases.
3. In the holes and slot location shown in above diagram, attach cases together with (4) 1/4-20 screws and
nuts provided. If these are Floor Model cases do not tighten screws until completing The Joining Floor
Model Base Section.
4. Slide the top join strip under the glass trim lip in top rear of case as shown in diagram above.
5. Attach Join Trim Strip with (2) 8-18 self-drilling screws.
Bekijk gratis de handleiding van Federal ITDSS4834, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Federal |
| Model | ITDSS4834 |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 10063 MB |
