Handleiding
Je bekijkt pagina 14 van 24
- 14
-
Placing Product into Case
- Do not exceed 100 pounds of weight per shelf. Heavy product should be distributed evenly across
the entire shelving area.
- Determine desired shelving location and angle before placing product in case. Product must be
removed to readjust shelf location and angle.
- Do not overhang the front of wire shelves with product. Product may overhang rear of shelf, but
allow a minimum of 1-1/2” between product and rear door. Improper clearance in front and rear of
shelf will block the refrigerated airflow and could cause product loss.
-Do not block the slots along the front or rear of the case display pan. Covering these slots will
block the refrigerated airflow and could cause product loss.
-The display pan is removable for cleaning and can become dislodged in shipment. To ensure
proper airflow and performance of the case, make sure that the display pan is pushed completely
down into evaporation tub. Check that the pan is installed properly before placing product the
display pans.
-Allow refrigerated models to run for at least two hours before placing pre-chilled product into unit.
Turn temperature control to the lowest possible position that maintains required interior cabinet
temperature.
-CASE SHOULD BE STOCKED WITH PRE-CHILLED PRODUCT
ONLY.
ATTENTION:
Refrigerated display cases are designed to operate in a maximum
environment of 75 DEG. F and 55% relative humidity. Exceeding these
limits could cause poor case performance and sweating of glass panels.
Bekijk gratis de handleiding van Federal ERR4828SS, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Federal |
| Model | ERR4828SS |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 2341 MB |
