Handleiding
Je bekijkt pagina 11 van 24
- 11
-
3. Hang one end of shelf light housing on the front notch of a shelf bracket and then the other end of shelf
light housing on the notch of the shelf bracket on the opposite end. Repeat for each additional shelf
tiers. NOTE: On models without shelf lights, use a shelf support instead of a shelf light housing.
4. Push shelf light cords into clear plastic clip located on inside of shelf brackets.
5. Remove the cap from the appropriate female light sockets. If socket is not being used for a shelf light,
the cap must be plugged into socket for entire light system to operate. NOTE: Grip each side of cap
firmly and wiggle and pull cap straight out of socket. Do not roll cap during removal.
6. Plug in each shelf light by aligning the male pins on the appropriate shelf light cord plugs with the
female light sockets and push together. NOTE: Do not roll plug during insertion.
7. Hang one end of the shelf support on to the rear notch of one shelf bracket and then on the rear notch of
the shelf bracket on the opposite side. Repeat for additional shelf tiers.
8. Place supplied shelving onto shelf supports as outlined in the appropriate “Shelf Installation” section of
this manual.
9. On units with sliding rear doors, re-install both rear doors by lifting top of door into top track and
swinging bottom of door onto bottom track. Install door labeled “inner door” first on inner track and
door labeled “outer door” second on outer track.
Shelves and shelf light quantity
It is not required that all shelves and shelf lights supplied with each case are used. The quantity of shelves
and shelf lights can be tailored to your specific needs. If the supplied quantity of shelves and shelf lights
are not required, cap unused female socket located in interior of the case mullion with caps supplied.
Failure to do so will prevent entire lighting system from operating.
Wire Shelves Installation
LOCATE LIGHT HOUSING IN SECOND
BRACKET NOTCH FROM FRONT
INSTALL SCREWS & SHELF RETAINER
CLIPS USING HOLES IN THE TOP OF
FRONT LIGHT HOUSING
ENGAGE LARGE FRONT
BOTTOM WIRE OF SHELF INTO
SHELF CLIP
1. For first time installation, it may be necessary to attach the clear plastic clips to each end of the front
light housing. Use the 6-32 x ¼ flat head screws supplied with unit to attach clear plastic clips to the 1/8
hole on each side of front light housing. This step may have already been performed at the factory for
you. Repeat for each front light housing
2. With rear sliding doors removed, place large front bottom wire of wire shelf into shelf clip.
3. Position the rear of shelf onto the rear shelf support.
4. Repeat 2 & 3 for each tier.
Bekijk gratis de handleiding van Federal ERR3628, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Federal |
| Model | ERR3628 |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 2341 MB |
