Extron TLI Pro 201 handleiding
Handleiding
Je bekijkt pagina 11 van 48
TLI Pro 201 • Installation Overview 3
Installation Overview
1. Before starting, download and install the latest versions of the following software:
• Toolbelt — Provides device discovery, device information, firmware updates, and configuration of
network settings, system utilities, and user management for TouchLink Pro interfaces.
• Global Configurator Professional and Global Configurator Plus — For setting up and configuring the
control processor, interface, and third-party touchpanel.
• GUI Designer — For designing layouts for Extron TouchLink Pro interfaces and third-party touch
interfaces.
• ControlScript Deployment Utility — Provides an integrated development environment for Extron control
systems programming.
See Configuration Software on page 23.
2. Obtain the following network information from your network administrator:
• DHCP setting (On or Off). If the DHCP setting is off, you also need:
• Interface IP address
• Subnet mask
• Gateway IP address
• Usernames — By default these are either admin or user.
• Passwords — The factory configured passwords for all accounts on this device have been set to the
device serial number. Passwords can be changed during configuration. They are case sensitive.
NOTE: If the device is reset to default settings, the passwords are reset to the defaults, which are
extron (for either admin or user accounts).
• MAC address — Make a note of the interface MAC address (see the label on the rear panel of the
device).
3. Mount the TLI Pro 201 in a standard rack, or use an under-table mounting kit (see Mounting on page 32). To
mount the third-party touch display follow the instructions provided by the manufacturer.
4. Connect cables to the TLI Pro 201 (see TLI Pro 201 Rear Panel Features and Connections on page 5).
• Connect an HDMI source to the HDMI input of the TLI Pro 201 (figure 2,
A
, on page 5) .
• Connect the HDMI output from the TLI Pro 201 (
B
) to the third-party touch display.
• Connect the USB port from the TLI Pro 201 (
C
) to the third-party touch display.
NOTE: The USB connection passes information to the TLI Pro 201 about where on the screen the
touch display was pressed. If you are using a non-touch display, connect a USB mouse to the USB
port on the TLI Pro 201 and use the mouse to click on screen buttons.
5. Connect the Ethernet cable. The TLI Pro 201 must be powered by PoE+ (seeLAN/PoE+ Port on page 6).
ATTENTION:
• Do not connect the power supply before reading the ATTENTION on page 8.
• Veuillez lire la partie « mises en garde » page 8, avant de mettre sous tension les écrans tactiles.
6. Set up the TLI Pro 201 for network communication:
• Connect the PC that you will use for setup, the control processor, and the TLI Pro 201 to the same
Ethernet subnetwork.
• Use the On-screen Menus (see page 11) or Toolbelt (see the Toolbelt Help File) to set the DHCP status
and, if necessary, the IP address, subnet mask, gateway, and related settings for the interface.
Bekijk gratis de handleiding van Extron TLI Pro 201, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Extron |
| Model | TLI Pro 201 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6183 MB |
