Extron RCP 101 Series handleiding
Handleiding
Je bekijkt pagina 6 van 6
6
For information on safety guidelines, regulatory compliances, EMI/EMF compatibility, accessibility, and related topics,
see the Extron Safety and Regulatory Compliance Guide on the Extron website.
© 2016 - 2021 Extron Electronics — All rights reserved. www.extron.com
All trademarks mentioned are the property of their respective owners.
68-3000-51 Rev. C
08 21
RCP 101 EU and RCP 101 MK • Setup Guide (Continued)
3. To save a recording to the USB device inserted into the RCP 101, click Configuration (
1
), System Settings (
2
),
and Recording Media Selection (
4
).
From the Recording Destination drop-down menu, or the Secondary Recording Destination drop-down menu, as
appropriate, select RCP USB.
1
1
1
2
2
2
3
3
3
4
4
4
5
5
5
Figure 10. SMP Web Page
4. To congure Front Panel Lockout, click Configuration (
1
), System Settings (
2
), and Executive Mode (
5
).
The options shown in figure 9 (see previous page) are available only when the RCP 101 is detected. By default:
• Front Panel Lockout (Executive Mode) is disabled (see Front Panel Lockout (Executive Mode) on page 2).
• Beep when button is pressed is enabled.
• Beep when alarm is triggered is disabled.
Select or deselect the appropriate checkbox to enable or disable those options.
Firmware
The rmware version installed on the RCP 101 must be compatible with the rmware installed on the SMP. To ensure this, the
RCP 101 rmware is managed automatically by the SMP series products. The rmware version of the RCP 101 can be found on
the SMP embedded web page under
Configuration > System Settings > Unit Identification.
When the remote control panel is rst connected to the SMP, the SMP checks the rmware version on the RCP 101 and, if
necessary, automatically updates the panel rmware to a compatible version.
If you update the SMP rmware, the RCP 101 rmware is automatically updated at the same time. For more information about
updating SMP rmware, see the SMP User Guide at www.extron.com.
Making a Recording
Once the SMP and RCP 101 are installed, and congured, follow these instructions to make a recording using the RCP 101:
1. Open the SMP web page to ensure the recording will be saved to the correct drive and that the USB drive, if required, is
attached to the correct drive.
2. Start the recording by pressing the Record button (figure 1,
A
, on page 1).
3. If required, add a chapter marking by pressing the Mark button (
E
).
4. If required, pause the recording by pressing the Pause button (
D
).
Restart the recording by pressing the Pause button a second time or by pressing the Record button.
5. End the recording by pressing the End button (
C
).
For more information, see the SMP User Guide at www.extron.com.
Bekijk gratis de handleiding van Extron RCP 101 Series, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Extron |
| Model | RCP 101 Series |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1483 MB |
