Extron FOXBOX Rx HDMI handleiding
Handleiding
Je bekijkt pagina 21 van 51
FOXBOX Tx/Rx HDMI • Installation 13
RS-232 connections
The Remote RS-232 port on the receiver only is for remote control of the receiver. The
RS-232 Over Fiber port on both units is for transmission of serial signals, such as projector
control signals, between the transmitter and receiver. See figure 9 to properly wire the
connectors.
Do not tin the wires!
Controlling
Device
Ground ( )
Receive (Rx)
Transmit (Tx)
Ground ( )
Receive (Rx)
Transmit (Tx)
Bidirectional
FunctionPin
TX
RX
Gnd
Transmit data
Receive data
Signal ground
ALARM
Tx Rx 1 2
RS-232
OVER FIBER
Tx Rx
REMOTE
RS-232
NOTE: Cross the Tx and Rx lines once between the source and the target.
Figure 9. RS-232 Over Fiber Connector
NOTE: The length of exposed wires is important. The ideal length is 3/16 inch (5 mm).
• Longer bare wires can short together.
• Shorter wires are not as secure in the connectors and could be pulled out.
Alarm outputs connection
ALARM
Tx Rx 1 2
Pin 1 and pin 2 are
shorted together when
no light is detected.
Do not tin the wires!
RS-232
OVER FIBER
Figure 10. Alarm Connector
NOTE: The length of exposed wires is critical (see the RS-232 connector NOTE above.)
Bekijk gratis de handleiding van Extron FOXBOX Rx HDMI, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Extron |
| Model | FOXBOX Rx HDMI |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7241 MB |
