EXSYS EX-44316-2 handleiding
Handleiding
Je bekijkt pagina 11 van 16
11
EX-44316-2 English
3. Layout and Connections
3.2 Connections
4. Jumper Einstellungen
For aux power (JP1), J2 must be connected to pc power supply! If not, the card wont work.
Attention! Never connect the power connector if the PC is on!
JP4:
+3.3V = The voltage level is set to 3.3V. (Factory Setting)
+5V = The voltage level is set to 5V.
If your device need a higher voltage level, then set the jumper to the
position +5V.
Only If set jumper S1_PWR-S16_PWR to ENA, then you can set the vol-
tage source with the jumper JP1. There are two different voltage sources
(Mainboard & Power Supply).
(If the jumper JP1 set to X5 / X12 then the power connector J2 must be
connected with the PC power supply)
I5 = 5Volt from Mainboard (Werkseinstellung)
I12 = 12Volt from Mainboard
X12 = 12Volt from Power Supply
X5 = 5Volt from Power Supply
JP1:
+3.3V +5V
ENA | DIS
JP6:
DIS = The function PME is disable. (Factory Setting)
ENA = The function PME is enable. Now the card can be activate
the computer through the serial ports.
But this should not be adjusted for standard applications.
J2:
Pin Belegung Pin Belegung Pin Belegung
1 3.3 Volt (Orange) 7 5 Volt (pre-charge) 13 12 Volt (pre-charge)
2 3.3 Volt (Orange) 8 5 Volt (Rot) 14 12 Volt (Gelb)
3 3.3 Volt (pre-charge) 9 5 Volt (Rot) 15 12 Volt (Gelb)
4 Ground (Schwarz) 10 Ground (Schwarz)
5 Ground (Schwarz) 11 Reserviert
6 Ground (Schwarz) 12 Ground (Schwarz)
X5 X12 I12 I5
© Copyright 2020 by EXSYS Vertriebs GmbH. All Rights Reserved
Bekijk gratis de handleiding van EXSYS EX-44316-2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | EXSYS |
| Model | EX-44316-2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1670 MB |
