Exquisit KGC231-60-E-050CB handleiding

118 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 54 van 118
Replacing the appliance door seal
1. Remove food from the appliance.
2. Pull the appliance door seals out of the appliance.
3. Clean the appliance door as usual.
4. Insert the new appliance door seal in the gaps.
5. Insert appliance door seal in the corners first and press/stroke it with your thumb.
6. If the appliance door seal is not evenly applied everywhere: carefully heat the
relevant areas with a hairdryer and pull out a little with your fingers.
Ø Inspect the appliance door seals regularly for soiling and damage.
Ø Grease and oil make the appliance door seals porous and brittle.
If grease or oil gets on door seals: Clean the appliance door seals,
including the interior parts, using a cloth and luke-warm water
with a little household detergent.
Defrosting
Automatic defrosting in the refrigerating compartment
The refrigerated area is equipped with an automatic defrosting system. Frost and ice
defrosts automatically. The condensation flows through the channel into the defrosting
hole and out into a condensation bowl on the rear of the appliance. The heat from the
motor evaporates the condensation.
Set the temperature so that the appliance does not constantly cool down without a
defrost phase. The temperature in the refrigerator drops (to below 0°C) and drinks and
fresh food freeze. The icing of the rear wall causes the energy consumption to rise very
sharply and the appliance efficiency drops.
Ø If the condensation does not run properly through the drain line
into the drip tray, check whether the drain line is clogged (see
chapter “Troubleshooting”).
Ø There must be no water on the floor or in contact with electrical
components.
Manual defrosting in the freezer compartment
After prolonged operation, a frost or ice layer may form in the freezer compartment. If
this ice layer reaches a thickness of 6 8 mm, defrost and clean the freezer
compartment. An excessive frost or ice layer increases the energy consumption. Before
defrosting, set the temperature regulator to the highest settings; the frozen goods store
the cold for a certain length of time.
1. Pull out the mains plug.
2. Empty the appliance and store the goods in a cool room.
3. For faster defrosting, place a vessel with warm water into the freezer
compartment.
4. Do not use mechanical objects to remove the ice layer.
5. First remove the large pieces of ice, then the small pieces from the appliance.
6. Clean the freezer compartment, including the interior parts, using a cloth and
luke-warm water with a little household detergent.
7. Rinse with clear water and wipe dry.
8. After cleaning, connect the appliance to the mains power supply again and switch
on.
Service and maintenance
Page 18
KGC231-60-E-050CB
Version 10/2023

Bekijk gratis de handleiding van Exquisit KGC231-60-E-050CB, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkExquisit
ModelKGC231-60-E-050CB
CategorieNiet gecategoriseerd
TaalNederlands
Grootte16963 MB