Handleiding
Je bekijkt pagina 13 van 25
Cleaning the printer
Recommended cleaning cycle: every ribbon change.
Maintenance accessory: cleaning card.
Although is recommended you clean the printer with every ribbon change, the Badgy has
an alert message to warn you that cleaning is required. The cleaning light on the control
panel will illuminate (after 400 cards).
If the printer is not cleaned, the light will remain illuminated and will then start flashing
after an 100 additional cards have been printed. In this event, immediately stop the work
in progress and proceed with the cleaning.
If you fail to carry out this maintenance, the alert message will continue and the
factory warranty will be invalidated for failure to comply with the contractual
maintenance requirements.
Repeated running of the cleaning card in the printer cleans the feed rollers, the cleaning rollers and the print head.
Proceed as follows:
Wait for 2 minutes before using the printer.
1
Remove card feeder from printer.
Remove any cards.
Insert cleaning card.
Replace card feeder into printer.
2
Open printer cover.
Remove ribbon cartridge.
Close cover.
Press control panel push
button for 1 second.
Cleaning starts.
cleaning card
13
Bekijk gratis de handleiding van Evolis Badgy 101, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Evolis |
| Model | Badgy 101 |
| Categorie | Printer |
| Taal | Nederlands |
| Grootte | 14861 MB |
