EverFocus EZN1240-SG handleiding
Handleiding
Je bekijkt pagina 13 van 17
12
6.2 EHN models
1. Stick the supplied Mounting Sticker on the surface to mark the 4 screw
positions. Drill the 4 screw-depth holes on the surface and then push the
supplied 4 Screw Anchors into the screw holes. Optionally drill the bottom 2
Cable Holes if you want to run the cables through the surface.
+ +
+
+
+
+
Screw Position x 4
Optionally drill the 2 Cable Holes if
you want to run the cables through
the surface.
2. Remove the camera cover by unscrewing the 3 cover screws using the
supplied Torx Wrench (Left Image). Screw the camera base to the surface
using the supplied 4 Screws (Right Image).
3. Optionally insert a micro SD card into the card slot (please refer to 2. Physical
Description).
4. Adjust the pan / tilt / rotate angles of the camera.
5. Connect the camera to power. You can either connect the camera to a 12VDC
power source or to a PoE switch using the PoE cable.
6. Connect the camera to the network using the supplied Cable Gland Kit. See 5.
Cables.
7. Now you can access the camera live view. See 7. Accessing the Camera.
Bekijk gratis de handleiding van EverFocus EZN1240-SG, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | EverFocus |
| Model | EZN1240-SG |
| Categorie | Bewakingscamera |
| Taal | Nederlands |
| Grootte | 6180 MB |
