Eventide BD600+ handleiding
Handleiding
Je bekijkt pagina 13 van 64
Understanding BD600 Profanity Delay Functions
BD600+Profanity Delay Chapter 2 Operation Page 9
Document Version 2.3
Connect analog audio inputs
Connect audio inputs to the two female XLR connectors on the rear panel. It is safe to connect and dis-
connect to the rear panel while the power is turned on. The inputs will probably come from a mixer
board. Supply an audio source at a level just below clipping. The BD600+'s level meters indicate input
level. Adjust your audio source's output such that with a maximum input signal, the level meters ide-
ally have all of the green segments and both of the yellow segments lit, but not the red segment. Since
the BD600+ has a very high dynamic range, it will give adequate performance on lower input levels.
Connect analog audio outputs
Connect audio outputs from the two male XLR connectors on the rear panel. It is safe to connect and
disconnect to the rear panel while the power is turned on.
Connect digital audio inputs
Connect the digital audio input to the female XLR connector on the rear panel. It is safe to connect and
disconnect to the rear panel while the power is turned on. There is no level control for the digital inputs
as these cannot overload.
To enable the digital inputs and disable the analog inputs, or vice-versa, press the BYPASS button
once or twice until the BYPASS button's LED is flashing, then press the CONFIG button until you see
3 AU, then press WAIT AND EXIT to see INPT. Now use REBUILD or RAMP TO ZERO to select ANA
or DIG as desired. After changing the input format you should also set the SYNC variable as appropriate
(see below).
Connect digital audio outputs
Connect digital audio output from the male XLR connector on the rear panel. It is safe to connect and discon-
nect to the rear panel while the power is turned on. There is no level control for the digital output as it cannot
overload. The digital audio output is always enabled, whether analog or digital input is in use.
Selecting the sample rate
The BD600+ uses digital processing for all internal operations and its sample rate can be selected in
various ways. The digital output is also at this sample rate.
To change the sample rate, press the BYPASS button once or twice until the BYPASS button's LED is
flashing. Now press the CONFIG button to enter configuration mode and press it again to go up
through the configuration levels until you reach 3 AU. Press the WAIT AND EXIT button twice to go to
the SYNC variable. The options are:
44.1K The sample rate is set to 44.1kHz using an internal quartz crystal source.
48K The sample rate is set to 48kHz using an internal quartz crystal source.
AES The sample rate is determined by the AES input.
WCLK The sample rate is determined by the Wordclock input.
DIG (BD600W+only) The sample rate is determined by the AES or the network, depending
on the selected input.
Note that automatic internal sample rate conversion allows satisfactory reception of an AES signal even when
the sample rate is not set to AES. This means that the unit could be set to 48K and satisfactorily receive a digital
Bekijk gratis de handleiding van Eventide BD600+, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Eventide |
| Model | BD600+ |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3523 MB |