Euro Appliances ECT600ACG handleiding
Handleiding
Je bekijkt pagina 7 van 21
7
Step.1
Put a towel or cloth on the work surface.Place the hob face
down on the protected surface.
Step.2
Apply the strip seal,supplied with the hob,which is for sealing
it onto the work surface.
Do not use silicone. Apply the seal to the edge of the bottom
of the hob,leaving about 3mm from the edge of the glass.
Apply the seal all around the circumference.
Cut any excess and bring the two ends of the seal together
so they match.
Step.3
Fix the brackets(4 pcs) on the front side and rear side by screw.Put the hob in the cut-
out cabinet,and make it centered.Ensure that the front edge of the hob is parallel to the
side edge of the work surface.
IMPORTANT: You must observe the ventilation
requirements shown in the drawing opposite.
IMPORTANT: There are ventilation holes around the
outside of the hob. YOU MUST ensure that these
holes are not blocked by the work top, when you put
the hob into position (see drawing opposite).
IMPORTANT: Do not use a silicon sealant to seal the
appliance against the aperture. This will make it
difficult to remove the hob from the aperture in future,
particularly if it needs to be serviced.
Carefully turn the hob back over and then gently lower it into the aperture hole that
you have cut out.
Add a wooden board to the bottom of the stove.
Fitting guidelines
The ceramic hob is manufactured to work with two-phase
alternating current (400V2N~50Hz).The voltage rating of the
ceramic hob heating elements is 230V. Adapting the ceramic
2
1
Bekijk gratis de handleiding van Euro Appliances ECT600ACG, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Euro Appliances |
| Model | ECT600ACG |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 4213 MB |
