Handleiding
Je bekijkt pagina 52 van 68
EN 20
Electronic controls
• The appliance will remain in pairing
mode for a maximum of 5 minutes.
• To factory reset your network settings,
press & hold the Wi-Fi button for 6
seconds. You will hear two beeps once
the appliance is reset.
• After resetting, the appliance will
automatically go into pairing mode.
• A solid Wi-Fi light indicates the
appliance is successfully connected to
the home network.
2. Press & hold the Wi-Fi button for 3
seconds until you hear a beep and see
the “”light flashing after it constantly
on for a few seconds.
3. Ensure Bluetooth is enabled on your
phone and open the ConnectLife app.
Look for the pop-up indicating that a
new appliance has been found. Tap the
button on the pop-up and follow the
instructions to proceed.
NOTE
First use
4. If a pop-up doesn't appear, tap the
button called “Add appliance” or “+” in
the app.
5. Locate “Refrigerator” in the device list
and select it.
6. Follow the instructions in the app to
connect your refrigerator. Once the
setup is complete, your refrigerator will
appear on your home screen.
18
• Your product is designed and built for domestic household use only. The product
must be correctly installed, located and operated in accordance with the
instructions contained in the Installation Instructions provided.
• Parameters provided in table are design parameters. Because of the various
reasons there will a slight deviation between actual dimension and design
parameter. The data listed are only for reference.
NOTE
19
First use
When reversing the door, the cabinet
installation can refer to installation
instructions.
1. To ensure the doors are fully
closed/sealed, conduct a test on
both doors following the installation
of decor door, such as using a sheet
of paper in-between the unit door
and its seal and closing the decor
door and seeing if there is any
tension observed when pulling the
sheet of paper-the sheet should hold
in place and not fall out.
2. For reversing the door, the hole
covers need to be removed from the
current location and refitted to cover
the new holes. If these break when
removing and can be replaced by
accessory bag.
NOTE
Cleaning before use
Before using the appliance for the first
time, wash the interior and all internal
accessories with lukewarm water and
neutral soap in order to remove the
typical smell of a brand new product,
then dry thoroughly.
Installation Positioning
Before installing, read the instructions
carefully for your safety and the
correct operation of the appliance.
WARNING
• Position the appliance away from
sources of heat such as stoves,
radiators, direct sunlight, etc.
• Maximum performance and safety
are guaranteed by maintaining the
correct indoor temperature for the class
of unit concerned, as specified on the
rating plate.
• The appliance operates well in the
corresponding climate type. The
appliance may not work properly if it is
left for a longer period at a temperature
above or below the indicated range.
Important!
It is necessary to have good ventilation
around the refrigerator to allow for the
dissipation of heat, high efficiency, and
low power consumption. For this
reason. sufficiently cleared space
should be available around the
refrigerator.
Leveling
The appliance should be level in order
to eliminate vibration. To make the
appliance level it should be upright and
adjusters should be in stable contact
with the floor. Also adjust the level by
unscrewing the appropriate level
adjustment in the front (use your fingers
or a suitable spanner).
Bekijk gratis de handleiding van Etna KCD8194ENF, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Etna |
| Model | KCD8194ENF |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 4947 MB |
