ETA Granny 1127 90000 handleiding
Handleiding
Je bekijkt pagina 22 van 52
Set the temperature regulator B2 into “100“ position and the timer regulator B3 into “ON”
position (indicator B4 indicating heating). Wait until the water reaches boiling point (the
indication lamp B4 turns OFF, and the indication lamp B5 will turn on) and let it boil for at
least 10 minutes. Let the appliance cool o and pour out the water. Potential short and
moderate smoke or smell is not a fault and a reason for taking the appliance back. Place
the appliance on a solid at and dry surface (e.g. kitchen table), out of reach of children. If
you are going to use the appliance for preserving in jars, insert the removable grid A5 and
ll the container with sucient volume of water, depending on the character and amount
of the prepared food. Plug the fork of the power supply A6 in the el. plug. The preserving
pot is now ready for use. The operation of the ETA preserving pot is easy and consists of
two main control features. It is the temperature regulator B2 and timer regulator B3. When
nishing or discontinuing the heating process, turn o the appliance by turning both of the
regulators counter-clockwise into „OFF/
o
C” position. Turn the switch B1 to position “O“
(indicators light will go o), and disconnect the power cord from the wall socket.
Over-heating protection
The preserving pot is equipped with a safety heat switch which will disconnect the heating
body in case of insucient or no amount of water. If water is not added the preserving pot
will automatically turn o and must be allowed to cool. If the preserving pot does not work
after having been connected to the el. outlet, in the lower part press button A7.
Temperature setting
The appliance is equipped with an in-built thermostat, which enables you to set the
temperature from approx. 30 °C to 100 °C (boiling point) with ± 8 % accuracy. When
reaching the set temperature, it is automatically maintained (depending on the setting of
the timer).
Setting the timer
Timer regulator B3 can be used in two modes.
a) automatic mode „20 – 120“
The timer enables you to set time in the range of 20 – 120 minutes. To increase the time
desired, turn the regulator clockwise. To decrease it, counter-clockwise. When the set time
runs out, the appliance turns o and a signal (1 beep) will sound.
b) mode of continuous operation „ON“
In this mode, the heating is not time limited. It is suitable for heating food, which needs to
be kept at a certain temperature longer than 120 minutes. You can set the mode by turning
the regulator counter-clockwise into the “ON”. Do not turn the appliance on without water.
Do not leave the appliance running unattended and keep an eye on it throughout the entire
food preparation process!
c) mode „OFF“ the timer is o.
NOTE
– The appliance is equipped with a reached temperature indicator switch B1. If you turn it
on (position “I”), the appliance will beep loudly to give you notice about the temperature
being reached. This is good especially when you need to count down exact time of
heating from the point when the pot reached the set temperature. You can thus avoid
the time dierence caused by time when the pot is only heating (the time to reach the
set temperature is individual and depends on the volume of water, ambient temperature
etc.)
EN
22 / 51
Bekijk gratis de handleiding van ETA Granny 1127 90000, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | ETA |
| Model | Granny 1127 90000 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5195 MB |
