ETA Fenix 1233 90000 handleiding
Handleiding
Je bekijkt pagina 29 van 60
REPLACING THE HEPA FILTER (A7)
When removing the HEPA filter, proceed according to Fig. 7. Insert the new/clean HEPA
filter into the dust container a reverse order.
Notes
– For hygienic purposes we recommend that you empty the container and clean the
HEPA filter after each use.
– Maximum suction power can be achieved when the HEPA filter are clean and the
dustbag is empty.
– Every time you empty the dust container, we recommend that you also clean the HEPA filter.
– When you are vacuuming very fine dust, the HEPA filter pores might get clogged. This
reduces the air flow and reduces the suction power. In such a case, the filter and the
separator need to be cleaned even though the container is not full yet.
Clean the surface of the vacuum cleaner and adaptor with a soft wet cloth. Do not use any
rough and aggressive detergents!
Accessories
After any vacuuming it is recommended to check visually the brushes or collectors for
possible impurities. If there are some impurities, remove them.
Floor nozzle with rotary brush / Small turbo brush
Remove any dirt (especially hair, animal hairs, etc.) stuck to the brush with the cleaning tool
L (or other suitable). To make cleaning easier, the brush can be removed (Fig. 9). Now you
may easily clean the brush (rinse it in running water).After wash the roller brush, please dry
the shaft at end of brush (milky plastic location) with damp cloth to avoid rusting. After the
maintenance, apply a reverse procedure to install the brush in the nozzle and secure it.
Caution
Do not water the floor nozzle D and the small direct-drive turbo brush G
in running water directly, it will damage motor and PCB.
Dust container
Clean the surface and the inside of the container A4 with a soft wet cloth.
Separator (Fig. 8, 10)
Rinse the separator A8 under running water. Allow the parts to dry out properly before
their re-use.
Caution
– When removing the filter system (i.e. separator A8, HEPA filter A7)
and subsequent cleaning of the container A4, it is necessary to
keep the vacuum cleaner upright and never turn the vacuum
cleaner upside down.
– Never rinse the container A4 under running water and never
immerse it in water.
EN
29 / 58
Bekijk gratis de handleiding van ETA Fenix 1233 90000, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | ETA |
| Model | Fenix 1233 90000 |
| Categorie | Stofzuiger |
| Taal | Nederlands |
| Grootte | 6644 MB |
