ETA Fenité Sonic Clean 0353 90000 handleiding

Niet gecategoriseerd

ETA

44 pagina's

PDF beschikbaar

Handleiding

19 / 3918

C – USB cable *

* USB cable: A source with USB terminal may be connected to USB cable (for

example AC power adapter, backup power source, etc.).

III. INSTRUCTIONS FOR USE

Before using the appliance, its battery must be charged rst. Charging is

possible with the enclosed USB cable from the mains, i.e. an AC adapter,

or a backup power source. While charging, the appliance cannot be used (with

the connected cable).

CHARGING

– Before the rst use or if the appliance was not used for a long time, charge it

completely.

– The standard charging time is approximately 2 hours. and the fully

charged accumulator allows for the operating time of up to 60 minutes. The

operating time decreases depending on the appliance loading and due to the

accumulator ageing and wear and tear.

1. Make sure the appliance is switched o󰀨.

2. Connect the enclosed USB cable to the power supply terminal, and connect

the other side to a power source, for example to a compatible AC power

adapter, or to a backup power source. While charging, the appliance cannot

be in use. If the appliance is turned on and you start charging, the appliance

shall switch off.

3. Do not exceed the designated charging time!

Charging light signal (A5)

Red ashing Indication of charging in progress

Permanent red lighting

Indication of a fully charged accumulator

(an acoustic signal sounds)

Optimise the battery service life

– Do not leave USB cable connected to the appliance.

– During charging or regular operation, the appliance heats up, which is

a normal phenomenon, and not a reason for a complaint.

CONTROL

– By long pushing of button A1 (approx. for 2 seconds) you switch the appliance

on/o󰀨. Upon switching on and o󰀨 an acoustic signal sounds.

– After short pushing of button A1 you may switch between 2 modes ( / ).

An acoustic signal sounds with every mode switching and the light control of

the particular mode lights up (BLUE).

– By short pushing of button A2 you may set the intensity. The set intensity

level is signalled by light control A4 (ORANGE - low intensity; GREEN - high

intensity). The intensity may be set for both modes ( / ) and an acoustic

signal sounds with every switching.

USE

With use of acoustic vibrations (frequency of 24 000 Hz) the appliance

thoroughly cleans the skin and removes dead skin cells. It also improves

absorption of various cosmetic preparations and softens the skin.

Skin cleansing mode “ ” (Fig. 2)

1. Moisten your face skin.

2. Switch on the appliance and set the skin cleansing mode “ ”. If needed,

you may also set the intensity level.

3. Place the stainless-steel part of the head (B1/B2) to the face skin using

a slight pressure and move it evenly over the entire face skin, as shown

on g. 2.

4. After the work termination, switch the appliance o󰀨 and wash your face with

water.

Bekijk gratis de handleiding van ETA Fenité Sonic Clean 0353 90000, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.