ETA Fenité 5353 90000 handleiding
Handleiding
Je bekijkt pagina 20 van 48
20
EN
/ 41
B – Backlit LCD
B1 – Set mode icon - high intensity
B2 – Set mode icon - low intensity
B3 – Set mode icon - positive ionisation
B4 – Set mode icon - negative ionisation
B5 – Remaining operation time (in minutes)
B6 – Symbol Minutes
B7 – Battery level indicator
C – Accessories
C1 – Silicone case (skin cleansing)
C2 – Protection case
D – Charging stand
E – USB cable *
* USB cable: A source with USB terminal may be connected to USB cable
(for example AC power adapter, backup power source, etc.).
III. INSTRUCTIONS FOR USE
Before using the appliance, its battery must be charged rst. Charging is
possible with the enclosed USB cable from the mains, i.e. an AC adapter,
or a backup power source.
Charging stand D can also be used for charging
the battery.
CHARGING
– Before the rst use or if the appliance was not used for a long time,
charge it completely.
– The standard charging time is approximately 2 hours. and the
fully charged accumulator allows for the operating time of up to 100
minutes. The operating time decreases depending on the appliance
loading and due to the accumulator ageing and wear and tear.
1. Make sure the appliance is switched o.
2. Connect the appliance to the power source (battery charger) using USB
cable or use the charging stand, which can also be connected to the to
the power source (battery charger) using USB cable, and then place the
appliance on the stand correctly (as shown on fig. 1).
If the appliance is
turned on and you start charging, the appliance shall switch off.
3. Do not exceed the designated charging time!
Note
Battery level and charging state are displayed by indicator B7
(the indicator is ashing during the charging process and lighting
continuously as soon as the charging process has been completed).
Optimise the battery service life
– Do not leave USB cable connected to the appliance.
– During charging or regular operation, the appliance heats up, which is
a normal phenomenon, and not a reason for a complaint.
CONTROL
– By long pushing of button A1 (approx. for 1 sec.) you switch the
appliance on/o. Upon switching on and o an acoustic signal sounds.
– Press short A1 button to switch over the modes. Currently set mode is
shown by LED indicators on the display (B1, B2, B3, B4).
USE
With use of acoustic vibrations (frequency of 24 000 Hz) the appliance
thoroughly cleans the skin and removes dead skin cells. It also improves
absorption of various cosmetic preparations and softens the skin.
Galvanic current technology:
– positive ionisation (Ion+) – for deep skin cleansing
– negative ionisation (Ion-) – for deep application of cosmetics
Bekijk gratis de handleiding van ETA Fenité 5353 90000, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | ETA |
| Model | Fenité 5353 90000 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3982 MB |
