ETA 274790010 handleiding
Handleiding
Je bekijkt pagina 100 van 140
EN
EN - 100
Problem Possible Causes What To Do
Spots and filming
on glasses and
flatware
Extremely hard water
Low inlet temperature
Overloading the dishwasher
Improper loading
Old or damp powder detergent
Empty rinse agent dispenser
Incorrect dosage of detergent
To remove spots from glassware:
Take out all metal utensils out of the dishwasher.
Do not add detergent.
Choose the longest cycle.
Start the dishwasher and allow it to run for
about 18 to 22 minutes, then it will be in the
main wash.
Open the door to pour 2 cups of white
vinegar into
the bottom of the dishwasher.
Close the door and let the dishwasher com-
plete the cycle. If the vinegar does not work:
Repeat as above, except use 1/4 cup (60
ml)of citric acid crystals instead of vinegar.
Cloudiness
on glassware
Combination of soft water and
too much detergent
Use less detergent if you have soft water
and select a shortest cycle to wash the
glassware and to get them clean.
Yellow or brown
film on inside
surface
Tea or coee stains
Using a solution of ½ cup of bleach and 3 cups
warm water to remove the stains by hand.
WARNING: You have to wait for 20 minutes
after a cycle to let the heating elements cool
down before cleaning interior; otherwise,
burns will happen.
Iron deposits in water can
cause an overall film
You have to call a water softener company
for a special filter.
White film on
inside surface
Hard water minerals
To clean the interior, use a damp sponge
with dishwasher detergent and wear rubber
gloves. Never use any other cleaner than
dishwasher detergent for the risk of foaming
or suds.
Detergent left in
dispenser cups
Dishes block detergent cups Re-loading the dishes properly.
Steam Normal phenomenon
There is some steam coming through the
vent by the door latch during drying and
water draining.
Black or gray
marks on dishes
Aluminum utensils have rubbed
against dishes.
Use a mild abrasive cleaner to eliminate
those marks.
Water standing in
the bottom of the
tub
This is normal
A small amount of clean water around the
outlet on the tub bottom keeps the water
seal lubricated.
Water flow out Damaged or detective drain pump Replace the drain pump
Dishwasher leaks
Overfill dispenser or rinse aid
spills
Be careful not to overfill the rinse aid dis-
penser.
Spilled rinse aid could cause oversudsing
and lead to overflowing. Wipe away any
spills with a damp cloth.
Dishwasher isn‘t level Make sure the dishwasher is level.
Bekijk gratis de handleiding van ETA 274790010, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | ETA |
| Model | 274790010 |
| Categorie | Vaatwasser |
| Taal | Nederlands |
| Grootte | 13975 MB |
