Estella 348PEM9 handleiding
Handleiding
Je bekijkt pagina 10 van 16
www.EstellaEquipment.com10
USER MANUAL
VERIFICATION OF THE CORRECT ELECTRICAL CONNECTION
Plug the cable into the power socket; position the switch to "FWD" (FIG. 7).
The direction of rotation of the worm must be counterclockwise in extruding mode. If it turns in the opposite
direction, disconnect the machine from the power supply and contact our nearest dealer.
Note: In machines connected to a single-phase line and specifically designed for this system, the rotation
direction will be defined directly by the manufacturer.
VERIFICATION OF THE PRESENCE AND EFFICIENCY OF GUARDS AND SAFETY DEVICES
Check that the machine stops when you open the top lid.
The machine must NOT work when the lid is open.
VERIFICATION OF THE EFFICIENCY OF THE EMERGENCY STOP BUTTON (FIG. 7)
With the machine connected to the electricity and the accessory tool moving, press the “OFF” button (5).
The machine must stop.
MACHINE START-UP (FIG. 7)
To start the machine, press the “ON” button (4) after having set the selector switch to “FWD” / kneading mode
(1) or “REV” / extruding mode (2). After having correctly plugged the cable into the power socket, the machine
will start. If the switch is set to OFF, the machine will not start.
MACHINE STOP (FIG. 7)
To stop the machine, turn the machine “OFF” (5) (FIG. 7).
START UP AND SHUT DOWN
Bekijk gratis de handleiding van Estella 348PEM9, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Estella |
| Model | 348PEM9 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2688 MB |
