ESI Waveterminal 2496 handleiding
Handleiding
Je bekijkt pagina 4 van 38
5
2. Hardware Installation
To install all components of the WT2496 properly, you should install the PCI card first and
make all audio and header pin connections before
you install the WT2496 Driver and the
Control Panel. If you follow the instructions in this section in the sequence that it is written,
you will have properly installed all components. After the WT2496 has been installed, you
may need to reinstall a part or all of your digital audio recording applications.
WHAT’S IN THE BOX
The WT2496 is shipped with the following contents:
1. WT2496 PCI card
2. Driver CD
3. This manual
4. 2-pin header connector cable
MINIMUM SYSTEM REQUIREMENTS
Because the WT2496’s dependence on the CPU is very low, you can use the WT2496 on
virtually any Pentium-based system. Your first consideration should be the system
requirements of the software you will be using. If your digital audio application's system
requirements are met, then the WT2496 will run without any problems.
1. Intel Pentium II CPU
2. 64MB of RAM
3. One available PCI slot
4. Microsoft Windows 98 SE/ME/2000/XP Operating System
5. Ultra DMA 33 hard disk drives
RECOMMENDED SYSTEM REQUIREMENTS
Your digital audio application’s system requirements should be checked first, as the
WT2496’s dependence on the system resources is very low. As a general rule, however,
digital audio applications perform better with faster clock speed and more RAM.
1. Intel Pentium III 600MHz CPU or higher
2. More than 256MB of Ram
3. One available PCI Slot
Bekijk gratis de handleiding van ESI Waveterminal 2496, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | ESI |
| Model | Waveterminal 2496 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6320 MB |
