Ermenrich Ping SM80 handleiding

Niet gecategoriseerd

Ermenrich

37 pagina's

PDF beschikbaar

Handleiding

Detection of circuit breakers

1. Remove the circuit breaker box to uncover the wires.

2. Adjust the receiver to a high sound.

3. Move the sensor of the receiver along each wire of a circuit breaker. Note that the signal may be stronger in case of a few wires on the

same AC phase. When the sensor of the receiver touches the wire of the target circuit breaker, the sound stops (no sound point), while

the receiver emits the sound when the sensor is near either side of the testing wire.

4. Move the sensor of the receiver near the sides of each wire. When the sensor is directly above the wire, the sound becomes high-

pitched; this is the peak signal point of the wire (approx.1–2 inches or 2–5cm above the wire). Hold the sensor in the peak sound point

and turn o the testing circuit breaker. If the sound signal stops, it means that the testing circuit breaker is the target circuit breaker.

Do not turn o the equipment that must not be interrupted.

To test the circuit breakers of such systems, scan all the phase wires entering the testing circuit breaker box. The receiver will emit the

sound when the sensor is near the sides of the testing wire; and the sound will stop when the sensor is directly above the testing wire.

Pinpointing for wall drilling

1. Place the transmitter for one side of a wall to be drilled, and place the receiver from the other side of the wall.

2. Connect the black alligator clip to a neutral wire of the electrical outlet. Clamp the red alligator clip to the phase wire of the electrical outlet.

3. Move the sensor of the receiver near the wall surface, and mark the places where any signal has been received (near the expected drill points).

4. Trace the buried wires or pipes, if necessary (see the description above). Mark the point on the wall as appropriate.

5. To mark an exact point for drilling, trace the exact transmitter location: wind up the alligator clips around the transmitter, clamp the alligator

clips together, and x the transmitter on the wall with an adhesive tape. Scan the opposite surface of the wall with the sensor of the receiver.

The peak sound signal will point at the exact location of the transmitter.

Sound Sound

Sound SoundNo sound

Sound

Peak

Weak

No sound

Sound

Weak signal

(±1.5m)

Peak

signal

±1.5 feet

Bekijk gratis de handleiding van Ermenrich Ping SM80, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.