Ermenrich Ping SM30 handleiding
Handleiding
Je bekijkt pagina 5 van 31
5
EN
Ermenrich Ping SM30 Stud Detector
Please carefully read the safety instructions and the user manual before using this product. Keep away from children. Use
the device only as specified in the user manual.
Getting started
• Open the battery compartment cover (16) and insert a battery according to the correct polarity. Close the cover.
• Press the Power button (9) to turn the device on or off. The device enters the scanning on the ½" (13mm) depth mode by
default. To change the mode, press the Mode button (10).
Calibration
Place the device flat against any surface that is free of studs, metal and AC cables. Turn the device on and select the desired
mode. Press and hold the Scan button (11) until the signal strength bars have decreased and the beeping sound is heard. This
indicates successful calibration. Do not move the device until the calibration is complete. Wait for 3 seconds after the calibration
is complete before using the device.
Calibration must be done each time a new mode is selected.
Usage
Stud detection mode
The device can scan the surface for wooden and/or metal studs at a depth of ½" (13mm), 1" (25mm), and 1½" (38mm). To
change between the modes, press the Mode button (10).
Choose the desired mode and complete the calibration. Place the device flat against the examined surface. Slowly move the
detector across the surface in the direction you want to scan. When the device detects the edge of a stud, the signal strength
bars (14) start increasing. Keep moving the device in the direction of the arrow indicator (12 or 13). When the device detects
the center of a stud, all of the signal strength bars are shown, and the word "CENTER" appears at the bottom of the screen.
Keep moving the device in the same direction until the signal strength bars decrease, and the other arrow appears on the
screen. This point indicates the second edge of the stud.
If you are receiving erratic scanning results, it may be a result of humidity, moisture within the wall cavity or drywall, or
recently applied paint or wallpaper that isn’t fully dried.
When scanning plaster, switch to metal detection mode to locate the nail heads in the wood lath.
Remember that studs are typically placed 16" or 24" (41cm or 61cm) apart and are usually 1½" (38mm) wide. Anything
different might not be a stud.
Metal detection mode
You can adjust the device sensitivity in the metal detection mode. Maximum sensitivity is ideal for a quick approximate
detection of a metal object, while reduced sensitivity narrows the search area and gives the more precise location of it.
Press the Mode button (10) to select the metal detection mode. Calibrate the device to maximum sensitivity by holding it in the
air and pressing the Scan button (14). Calibrating in the air ensures that the device is away from any possible metal. Place the
device flat against the examined surface. Slowly move the detector across the surface in the direction you want to scan. Use
the center mark (1) to mark the point where the most signal strength bars are (14) on the screen (the device will also be steadily
beeping). Keep moving the device in the same direction until the signal strength bars decrease. Start moving the device in the
opposite direction and mark the point where the signal strength bars are the fullest. The midpoint between the two marks is the
center of a metal object.
Bekijk gratis de handleiding van Ermenrich Ping SM30, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Ermenrich |
| Model | Ping SM30 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3562 MB |
