EPEVER DR2210N handleiding
Handleiding
Je bekijkt pagina 25 van 34
22
www.solarv.de
Copyright © 2021 SolarV GmbH
B. Over Voltage Disconnect Voltage > Over Voltage Reconnect Voltage
C. Low Voltage Reconnect Voltage > Low Voltage Disconnect Voltage ≥ Discharging Limit
Voltage.
D. Under Voltage Warning Reconnect Voltage > Under Voltage Warning Voltage ≥
Discharging Limit Voltage.
E. Boost Reconnect Charging voltage > Low Voltage Reconnect Voltage.
Lithium Battery Control Voltage Parameters
The parameters are in 12V system at 25 ºC, please double the values in 24V system.
Battery type
Voltage parameter
LiFePO
4
(4S)
Li-NiCoMn
(3S)
User
Over Voltage Disconnect Voltage
15.6V
13.5V
9~17V
①
Charging Limit Voltage
14.6V
12.6V
9~17V
①
Over Voltage Reconnect Voltage
14.5V
12.5V
9~17V
①
Equalize Charging Voltage
14.5V
12.5V
9~17V
①
Boost Charging Voltage
14.5V
12.5V
9~17V
①
Float Charging Voltage
13.8V
12.2V
9~17V
①
Boost Reconnect Charging Voltage
13.2V
12.1V
9~17V
①
Low Voltage Reconnect Voltage
12.4V
10.5V
9~17V
①
Under Voltage Warning Reconnect
Voltage
12.5V
11.0V
9~17V
①
Under Volt. Warning Volt.
12.0V
10.5V
9~17V
①
Low Volt. Disconnect Volt.
11.0V
9.3V
9~17V
①
Discharging Limit Voltage
10.8V
9.3V
9~17V
①
①The voltage range of DR1106/2106/3106N-DDB/DDS is 9-16V.
The following rules must be followed when modifying the value of lithium battery.
A. Over Voltage Disconnect Voltage>Over charging protection voltage(Protection Circuit
Modules(BMS))+0.2V
※
;
B. Over Voltage Disconnect Voltage>Over Voltage Reconnect Voltage＝Charging Limit
Voltage ≥ Equalize Charging Voltage＝Boost Charging Voltage ≥ Float Charging
Voltage>Boost Reconnect Charging Voltage;
C. Low Voltage Reconnect Voltage>Low Voltage Disconnect Voltage ≥ Discharging Limit
Voltage;
D. Under Voltage Warning Reconnect Voltage>Under Voltage Warning Voltage≥
Discharging Limit Voltage;
E. Boost Reconnect Charging voltage> Low Voltage Reconnect Voltage;
F. Low Voltage Disconnect Voltage ≥ Over discharging protection voltage
(BMS)+0.2V
※
.
WARNING:The voltage parameters of lithium battery can be set, but you
must
refer to the voltage parameters of lithium battery BMS.
WARNING: The required accuracy of BMS shall be at least 0.2V. If the deviation is
higher than 0.2V, the manufacturer will assume no liability for any system malfunction
caused by this.
Bekijk gratis de handleiding van EPEVER DR2210N, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | EPEVER |
| Model | DR2210N |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5618 MB |
