Elysia XMAX Qube handleiding
Handleiding
Je bekijkt pagina 5 van 19
5
Low Gain
The make-up gain of the low band of the xmax. This controller
compensates for the loss in gain caused by the low band’s compression
process. It can also be used as a low shelf EQ.
Soft Clip Limiter (s-clip) (page 12)
The Soft Clipper was designed to limit short, loud transients to prevent
subsequent A/D converters from clipping. However, the circuit does not
behave like a classic brick wall limiter, but more like an analog tape
machine driven into saturation: it rounds the peaks instead of making
hard cuts. You can see the amount of peak reduction at the correspond-
ing s-clip meter.
Level
The master output of the xmax. The control oers up to +/- 12 dB of
amplication/reduction to set the output level for the following devices.
Metering
The display for the gain reduction of the mid, low and side bands as well
as the soft clip limiter peak reduction. Shows the amount of compression
and peack reduction measured in dB as an optical support for the
acoustic events.
Low Fequency Mono Maker (lowmo) (page 11)
A high-pass lter aecting only the side band, ltering the low frequen-
cies below 150Hz (LED red: active).
Increased Compressor Ratio (punch)
A higher ratio (1:1.45 to 1:2.55) for all compressor bands (LED red: active).
Hit it!
Activates the xmax (LED yellow) or deactivates (LED white) it with a
hardwire bypass (Meterings remain active). In deactivated state, the
input is directly routed to the output by a hardwire bypass.
Bekijk gratis de handleiding van Elysia XMAX Qube, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Elysia |
| Model | XMAX Qube |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1889 MB |
