Handleiding
Je bekijkt pagina 31 van 252
Installation - ENGLISH 31
DANGER!
There is a danger of physical injury due to sharp edges during the installation of the product.
DANGER!
• Never turn on a malfunctioning product. If the product is malfunctioning, broken or has a cracked
surface, pull the power plug, switch off the circuit breaker and contact the support.
• A malfunctioning product may cause electric shock.
• To ensure your safety, the electric connection must be made by a qualified electrician. The plug must
be connected to an earthed socket.
• Any changes to the electrical wiring in your home must only be made by a qualified electrician.
Before installing the hob
Installation requirements:
• Make sure that the work surface is square and level, and no structural parts interfere with space requirements.
• Make sure that the work surface is made of a heat-resistant and insulated material.
• If the hob is installed above an oven, make sure that the oven has a built-in cooling fan.
• The installation must comply with all clearance requirements and applicable standards and regulations.
• Make sure there is a good isolating switch in the permanent wiring that completely cuts off the power supply from the
electricity network. The switch must be installed in a way that follows local wiring rules and regulations.
• Make sure that the isolating switch is of an approved type and provide a 3 mm air gap contact separation in all poles
(or in all active phase conductors if the local wiring rules allow for this variation of the requirements).
• Make sure that the isolating switch is easy to reach after the hob is installed.
• If you are unsure about the installation, ask the local building authorities and look at the by-laws.
• Make sure that the wall surfaces around the hob are heat-resistant and easy to clean (for example, use ceramic tiles).
• Make sure the connection parameters of the product (fuse rating, voltage and frequency) match the mains power
supply. If in any doubt, consult a qualified electrician.
• Use 1 fuses with a rating of 16 A.
• The usage voltage of the product is 220-240 V, 50/60 Hz (2L, N, E).
Before connecting the hob to the mains power supply
The hob must be connected to the mains power supply only by a qualified person.
• Check that the domestic wiring system is suitable for the power used by the hob.
• Make sure the connection parameters of the product (fuse rating, voltage and frequency) match the mains power
supply. If in any doubt, consult a qualified electrician.
• To connect the hob to the mains power supply, do not use adapters, reducers, or branching devices. They may cause
overheating and fire.
• The power cord must not touch any hot parts and must be positioned so it does not get hotter than 75 °C at any point.
After installing the hob
When the installation is complete (see section ), make sure that the following installation requirements are followed.
Installation requirements:
• Make sure that the power cord cannot be reached through cupboard doors or drawers.
• Make sure that there is a good flow of fresh air from outside the cabinetry to the bottom of the hob.
• If the hob is installed above a drawer or cupboard space, make sure there is a thermal protection barrier below the
bottom of the hob.
• Make sure that the isolating switch is easy to reach after the hob is installed.
Connect the mains power
Before installation, see section "Safety during installation", page 5 and section "Installation options and requirements",
page 30.
Bekijk gratis de handleiding van Elvita CIH4332S, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Elvita |
| Model | CIH4332S |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 23134 MB |
