Elvita CDM6601V handleiding
Handleiding
Je bekijkt pagina 45 van 301
Installation - ENGLISH 45
Change to the longer feet
You can replace the pre-installed 90mm long feet with the supplied 110mm long feet if needed.
1. Carefully lay the dishwasher on its back.
2. Unscrew the two 90mm long front feet.
3. Unscrew the 90mm long rear foot with a cross-head screwdriver by turning the screw.
4. Screw the two 110 mm long front feet onto the dishwasher.
5. Screw the 110long rear foot onto the dishwasher with a cross-head screwdriver by turning the screw.
CAUTION! The feet must not protrude more than 100mm.
6. Lift the dishwasher to a standing position.
Level the machine
Level your dishwasher by adjusting the height of the front feet and the rear foot individually.
Check if there are any feet not touching the floor. If any foot is not touching the floor: screw out the foot until it makes
contact with the floor.
1. To adjust the rear foot, use a cross-head screwdriver and turn the screw.
2. To adjust the front feet, use a flat-head screwdriver and turn the front feet.
You can also turn the front feet by hand.
NOTE! The maximum adjustment height of the feet is 60mm with the longer feet.
Bekijk gratis de handleiding van Elvita CDM6601V, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Elvita |
| Model | CDM6601V |
| Categorie | Vaatwasser |
| Taal | Nederlands |
| Grootte | 34684 MB |
